User manual JVC KW-M24BT

[. . . ] Model name indication position See “Removing the trim plate” (P. 2 Before use Precautions #WARNING ÑÑ prevent injury or fire, take the To following precautions: • To prevent a short circuit, never put or leave any metallic objects (such as coins or metal tools) inside the unit. € Do not watch or fix your eyes on the unit’s display when you are driving for any extended period. € If you experience problems during installation, consult your JVC dealer. [. . . ] € Do not recharge, short, break up or heat the battery or place it in an open fire. Such actions may cause the battery to leak fluid. If spilled fluid comes in contact with your eyes or on clothing, immediately rinse with water and consult a physician. ÑÑ Removing the battery sheet Pull the battery sheet out from the remote controller to activate the battery. During tuner source, switches to broadcast stations received by the unit. ÑÑ Changing the battery of the remote controller CR2025 (+side) • Use a commercially available button battery (CR2025). € Insert the battery with the + and – poles aligned properly. €–If the effectiveness of the remote controller decreases, replace the battery. Indb 18 2017/09/15 11:56 Installation Installation Before Installation Before installation of this unit, please note the following precautions. #WARNINGS • If you connect the ignition wire (red) and the battery wire (yellow) to the car chassis (ground), you may cause a short circuit, that in turn may start a fire. Always connect those wires to the power source running through the fuse box. € Do not cut out the fuse from the ignition wire (red) and the battery wire (yellow). The power supply must be connected to the wires via the fuse. #CAUTION • Install this unit in the console of your vehicle. Do not touch the metal part of this unit during and shortly after the use of the unit. Metal part such as the heat sink and enclosure become hot. Tape around the wires that comes into contact with metal parts to protect the wires and to prevent short circuit. € Connect the speaker wires correctly to the terminals to which they correspond. The unit may be damaged or fail to work if you share the ¤ wires or ground them to any metal part in the car. € When only two speakers are being connected to the system, connect the connectors either to both the front output terminals or to both the rear output terminals (do not mix front and rear). For example, if you connect the ¢ connector of the left speaker to a front output terminal, do not connect the ¤ connector to a rear output terminal. € After the unit is installed, check whether the brake lamps, blinkers, wipers, etc. [. . . ] Ñ (Industry Canada) Notice IC This device complies with Industry Canada licenceexempt RSS standard(s). Operation is subject to the following two conditions: (1) This device may not cause interference, and t (2)  his device must accept any interference, including interference that may cause undesired operation of the device. CAUTION This equipment complies with FCC/IC radiation exposure limits set forth for an uncontrolled environment and meets the FCC radio frequency (RF) Exposure Guidelines and RSS-102 of the IC radio frequency (RF) Exposure rules. This equipment has very low levels of RF energy that is deemed to comply without maximum permissive exposure evaluation (MPE). [. . . ]