User manual JVC LT-23C50SU

[. . . ] ENGLISH DEUTSCH FRANAIS ITALIANO LT-23C50BU LT-23C50SU WIDE LCD PANEL TV BREITBILD-LCD-TV TLVISEUR GRAND CRAN LCD TV A PIENO SCHERMO LCD INSTRUCTIONS BEDIENUNGSANLEITUNG MANUEL D'INSTRUCTIONS ISTRUZIONI 50059358 2004 VICTOR COMPANY OF JAPAN, LIMITED 1004MKH-VT-VT Contents For your safety . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 1 Important Information . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 4 Remote Control Buttons . . . . . . . . . . . . . . . . . . . . . . . . . . . 5 Control Panel Buttons . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . [. . . ] When On is selected, the TV can only be controlled by the remote control handset. In this case the control panel buttons except " " button on the right side of the TV will not work. Selecting Menu Language Using or button select Language. Press or button to select menu language. EXT-2 Output From EXT-2 Output; TV, EXT-1 or EXT-4 can be given. These modes can be chosen by pressing or button on "EXT-2 OUTPUT". Audio Out Volume As you enter the Audio Out sound menu, Volume will be the only option. Selecting Mode Using Press or button select Mode. or button to change Mode. You can choose Mono, Stereo or Dual (I-II) mode, only if the selected channel supports that mode. You can also change sound mode directly pressing I-II button on your remote control. In case of bilingual broadcast (Dual Sound), you can select original or dubbed language using mode option. So when somebody listens to the original language from the loudspeakers, somebody else can listen to the dubbed language from headphone. To Store The Settings In the Sound Menu, all settings are stored automatically. Feature Menu Press "MENU" button, now you are in mainmenu. In the main menu, select Feature using or button. Then enter the Feature menu pressing / or OK button. Blue Back (During No Signal) The Blue Back Feature can be set by button to either On or Off or ENGLISH - 17 - To Store Settings In Feature menu all settings are stored automatically. Note: In EXT mode, you can choose NTSC 3. 58 and NTSC 4. 43 as well. Selecting Sound System Using or button on Sound System, you can change the standard to BG, DK, I, L, Lp. Selecting Fine Tuning You can use the Fine Tuning process for fine adjustment (after coarse adjustment), if you are not happy about the image on the screen. Use or button on Fine Tuning item, until getting the best image on the screen. Selecting Search To start the search process, press button for forward search or button for backward search. If a signal is found or reaches to end of the band after searching, press or buttons to continue search process. To stop the search process when you want, press or buttons at any time. Decoder (EXT-2) You can use this mode to connect any decoder to your TV. Press the or buttons to set it On or Off. [. . . ] Check if you have entered the correct frequency. The picture quality may degrade when two peripherals are connected to the TV at the same time. In such a case, disconnect one of the peripherals. No solution Switch your TV set off and on. If this does not work, switch off, remove the mains plug and call the service personnel; never attempt to repair it yourself. No Image on Display Screen Is the aerial connected properly? [. . . ]