User manual JVC MX-D452TR

[. . . ] Serial No. PART No. FMUN9002-181M [ U, UT, US, UB ] Warnings, Cautions and Others Avisos, precauciones y otras notas Advertncias, precaues e outras notas IMPORTANT for the U. K. DO NOT cut off the mains plug from this equipment. If the plug fitted is not suitable for the power points in your home or the cable is too short to reach a power point, then obtain an appropriate safety approved extension lead or consult your dealer. BE SURE to replace the fuse only with an identical approved type, as originally fitted. [. . . ] Press the 0 button on the left of the Disc button you want to insert the disc into. The disc tray slides out automatically. 2. Place a CD, with its label side up, onto the tray. or ATTENTION: To avoid malfunctions when you play a CD, please set the CD in the right place at the centre of the tray. CD Tray CORRECT INCORRECT 3. Repeat steps 1 to 3 to insert other discs into other trays. To continue putting discs into other trays, even if a tray is open, by pressing the 0 button of another disc tray, the open tray will close automatically, and the new disc tray will slide out. o To put an 8 cm CD into a tray, insert it so that it is aligned with the groove in the tray's centre. If a tray is open when the System switches to Standby mode, the tray is closed automatically. 13 English The Quickest Way To Start a CD Is With the One Touch Operation -------------------------------------------------- English Basics of Using the CD Player -- Normal Play To Play a Disc ---------------------------------------------- 1. Prepare the discs. CD FM /AM TAPE AUX 2. Press the CD </8 or DISC button (1-3) of the disc you want to play. When using the Remote Control, press the /8 button or the DISC (1 to 3) buttons. The first track of the selected disc will begin playing. The CD Player automatically stops when the playback finishes the last track of the CD. If these buttons are pressed while the tray is open, the tray is automatically closed and playback starts. Note: If the CD cannot be read correctly (due to scratches etc. ), "00 0000" appears on the display. To stop playing the disc, press the 7 button (or the 7/CLEAR button on the Remote Control). To stop playing and removing the disc, press the 0 button for the disc being played. Press the DISC button (1 to 3) or /8 button. Playing order of the CDs The selected CDs are played continuously in the following order. = DISC 1 = DISC 2 = DISC 3 = (back to the beginning) To cancel Continuous play, press the CONTINUE button again. The "CONT. " indicator on the display goes out and Normal Play is resumed. When using the Remote Control, press the PLAY MODE button while the CD Player is stopped to select a different Play mode. The "CONT. " indicator goes out and the next Play mode is selected. DISC Programming the Playing Order of the Tracks You can change the order in which the discs and tracks play, and select only the discs and tracks you want from among those loaded in the CD Player. o You can program up to 20 steps in any desired order from among the discs in the player. o You can only make a program when the CD Player is stopped. Use the Remote Control. PLAY MODE 1. Press the PLAY MODE button to select "PROGRAM". The display changes with each press of the PLAY MODE button as shown below. A. BASS EX S. MODE PRGM = PROGRAM = RANDOM = CONTINUE = No display = (back to the beginning) DISC The "PRGM" play mode indicator light up. If a program is already in progress, the last step of the program is displayed. [. . . ] In this case, leave the unit turned on for a few hours until the moisture evaporates, unplug the AC power cord, and then plug it in again. General Notes In general, you will have the best performance by keeping your tapes, CDs, and the mechanism clean. Store tapes and CDs in their cases, and keep them in cabinets or on shelves. Keep the Cassette Deck's tape doors and the CD trays closed when not in use. Heads If the heads become magnetized, the Unit will produce noise or lose high frequencies. [. . . ]