User manual JVC MX-J100

[. . . ] COMPACT COMPONENT SYSTEM KOMPAKT-KOMPONENTEN-SYSTEM SYSTEME DE COMPOSANTS COMPACT KOMPACTO KOMPONENTEN-SYSTEEM SISTEMAS DE COMPONENTES COMPACTOS IMPIANTO A COMPONENTI COMPATTO CA-MXJ100 STANDBY OPEN / CLOSE CD1 CD2 CD3 DISC CHANGE COMPACT PLAY & EXCHANGER DIGITAL AUDIO VOLUME COUNTER RESET CLOCK/TIMER + DEMO ACTIVE BASS EX. SOUND MODE ­ AUX FM/AM CD TAPE PROGRAM/SET TIMER ON/OFF SLEEP - TUNING TUNING + TAPE A/B CD REC START PHONES REPEAT REC/PAUSE AB DUBBING PROGRAM REPEAT /SET ACTIVE SOUND BASS EX. MODE COMPU PLAY CONTROL ­ PRESET + CD TAPE A/B TUNING MODE FM MODE CD TAPE FM/AM AUX DISC SKIP EJECT EJECT VOL. + FADE MUTING PLAY VOL. REC/PLAY ­ COMPACT FULL-LOGIC CONTROL CD SYNCHRO RECORDING RM­SMXJ100E REMOTE CONTROL DIGITAL AUDIO INSTRUCTIONS BEDIENUNGSANLEITUNG MANUEL D'INSTRUCTIONS GEBRUIKSAANWIJZING MANUAL DE INSTRUCCIONES ISTRUZIONI For Customer Use: Enter below the Model No. which are located either on the rear, bottom or side of the cabinet. [. . . ] The unit enters the volume setting mode. PROGRAM/SET On the unit ONLY: 5 Set the volume level when the unit is turned on. CLOCK/TIMER 1 Press CLOCK/TIMER until " TIMER" appears on the display. The indicator also starts flashing on the display. Press 4 or ¢ to set the volume, then press PROGRAM/SET. The unit enters source selecting mode. PROGRAM/SET 6 Press 4 or ¢ to select the · Each time you press the button, the timer setting modes change as follows: Clock time REC CLOCK TIMER source to play, then press PROGRAM/SET. · Each time you press 4 or ¢, the source changes as follows: FM TAPE MW LW CD 2 Press PROGRAM/SET. "ON TIME" appears for 2 seconds, then the unit enters on-time setting mode. PROGRAM/SET tunes into a specified preset FM station. MW: tunes into a specified preset MW station. LW: tunes into a specified preset LW station. · Make sure there is a CD on the currently selected disc number tray. · Make sure that a tape is in the deck whose deck indicator (A or B) is lit on the display. · Make sure that the tape direction is correct. FM: ­ 16 ­ English Using the Timers Continued English 7 When selecting "FM, " "MW, " or "LW. " Press 4 or ¢ to select the preset station number, then press PROGRAM/SET. The unit enters recording timer setting mode. If you want to continue the Recording Timer setting, go to step 3 of the Recording Timer setting procedure. 3 Press PROGRAM/SET. "ON TIME" appears for 2 seconds, then the unit enters on-time setting mode. PROGRAM/SET PROGRAM/SET 8 Press CLOCK/TIMER. The indicator stops flashing and remains lit. If you have set the Daily Timer with the unit turned on, turn off the unit. CLOCK/TIMER 4 Set the on-time you want the unit to turn on. 1) Press 4 or ¢ to set the hour, then press PROGRAM/ SET. 2) Press 4 or ¢ to set the minute, then press PROGRAM/SET. "OFF TIME" appears for 2 seconds, then the unit enters off-time setting mode. Using Recording Timer With Recording Timer, you can make a tape of a radio broadcast automatically. PROGRAM/SET How Recording Timer actually works The unit automatically turns on, tunes into the specified station, sets the volume level to the preset level and starts recording when the on-time comes. Then, when the off-time comes, the unit automatically turns off (stands by). The timer setting remains in memory until you change it. · There is a time limit in doing the following steps. If the setting is canceled before you finish, start from step 1 again. · If you have made a mistake while setting the timer, press CLOCK/TIMER once and start from step 1 again. 5 Set the off-time you want the unit to turn off (on standby). 1) Press 4 or ¢ to set the hour, then press PROGRAM/ SET. 2) Press 4 or ¢ to set the minute, then press PROGRAM/ SET. The unit enters the volume setting mode. PROGRAM/SET On the unit ONLY: 1 Put a recordable cassette into deck B. 2 Press CLOCK/TIMER until " REC" appears on the display. The indicator also starts flashing on the display. 6 Set the volume level when the unit is turned on. Press 4 or ¢ to set the volume, then press PROGRAM/ SET. CLOCK/TIMER The unit enters source selecting mode. · Each time you press the button, the timer setting modes change as follows: Clock time REC CLOCK TIMER PROGRAM/SET ­ 17 ­ 7 Select the preset station. 1) Press 4 or ¢ to select the band ("FM, " "MW, " or "LW"), then press PROGRAM/SET. 2) Press 4 or ¢ to select a preset channel number. PROGRAM/SET Using Sleep Timer With Sleep Timer, you can fall asleep to music. [. . . ] Nagy energiájú bemeneti jel rendellenes zajt generálhat és a rendszer károsodását okozhatja. Az alább leírt jelek még a maximális megengedett bemeneti szint alatt is a rendszer túlterhelését és a hangszóró tekercsek leégését okozhatják. 2) A magnódeck gyors elretekercselés során keletkez, magas frekvenciájú komponenseket tartalmazó intenzív jelek. 3) Egyéb berendezés be és kikapcsolásakor keletkez kattanó zaj. [. . . ]