User manual JVC MX-S5RMD

[. . . ] COMPACT COMPONENT MD SYSTEM CA-MXS5RMD COMPACT DIGITAL AUDIO INSTRUCTIONS For Customer Use: Enter below the Model No. which are located either on the rear, bottom or side of the cabinet. Retain this information for future reference. Serial No. LVT0354-001A [B] Warnings, Cautions and Others IMPORTANT for the U. K. [. . . ] On the remote control: Press ¢ or 4 repeatedly. · ¢ : Skips to the beginning of the next or succeeding tracks. · 4 : Goes back to the beginning of the current or previous tracks. To stop during play, press 7. To remove the disc, press 0 for the MD recorder. To go to another track directly using the number buttons Pressing the number button(s) allows you to start playing the track number you want. For track number 20, press +10, then 10. For track number 32, press +10, +10, +10, then 2. If the MD or track has a title The title will be shown at the center portion of the main display. (If a title is long and cannot be shown at a time, the unit scrolls the title to show the entire title. ) If you cannot insert an MD You have inserted an MD incorrectly and taken it off by force. In this case, MD loading slot rejects MD insertion. If this occurs, wait for about one minute with the unit turned on until a mechanical sound comes out of the MD mechanism. ­ 29 ­ Continued Programing the Playing Order of the Tracks -- Program Play You can arrange the order in which the tracks play before you start playing. You can program up to 32 tracks. To stop during play, press 7. To exit from Program play mode, press PLAY/REC MODE (or PLAY MODE on the remote control) once or twice so that the unit enters another playback mode (Random play or Normal play mode). 1 Load an MD. · If the current playing source is not the MD recorder, press MD # / 8, then 7 before going to the next step. To check the program contents Before playing, you can check the program contents by pressing ¢ or 4 on the remote control. · ¢ : Shows the programed tracks in the programed order. · 4 : Shows them in the reverse order. 2 Press PLAY/REC MODE (or PLAY MODE on the remote control) so that " MD PROGRAM" appears in the main display. · Each time you press the button, play mode changes as follows: Program play Random play (MD PROGRAM) (MD RANDOM) Normal play (MD NORMAL) To modify the program Before playing, you can erase the last programed track by pressing CANCEL. Each time you press the button, the last programed track is erased from the program. To add tracks in the program before you start play, simply select track numbers you want to add. To erase the entire program, before or after play, press and hold CANCEL on the unit until "MD PROGRAM ALL CLEAR" appears in the main display. · When you eject the disc or turn off the unit, the entire program is also erased. 3 Select the track. On the unit: Push the joy control rightward (¢ ) or leftward (4 ) to select the track number, then press SET. On the remote control: Press the number buttons. · For how to use the number buttons, see "To go to another track directly using the number buttons" on page 29. Track No. Total playing time If you try to program a 33rd step "MD PROGRAM FULL" will appear in the main display. If your entry is ignored You have tried to program a track that does not exist on the MD (for example, selecting track 14 on an MD that only has 12 tracks). When selecting track 5 · If the selected track has a title, it will be shown at the center portion of the main display. [. . . ] The AM loop antenna is too close to the unit. The FM antenna is not properly extended and positioned. The path between the remote control and the remote sensor on the unit is blocked. The main AC power cord is not plugged in. [. . . ]