User manual JVC RC-BZ5

[. . . ] CD PORTABLE SYSTEM RC-BZ6BU INSTRUCTIONS For Customer Use: Enter below the Model No. which are located either on the rear, bottom or side of the cabinet. Retain this information for future reference. Serial No. LVT0490-002A [B] Warnings, Cautions and Others IMPORTANT FOR LASER PRODUCTS REPRODUCTION OF LABELS 1 CLASSIFICATION LABEL, PLACED ON EXTERIOR SURFACE IMPORTANT for the U. K. [. . . ] During, or before playback, press the REPEAT button on the Remote Control to select the Repeat mode. The Repeat indicator changes with each press of the button, as shown below. = ALL =blank display = (back to the beginning) : Repeats one track. To exit Repeat mode, press the REPEAT button until the Repeat indicator on the display goes out. Search Play ------------------------ During playback, hold down the 4 or ¢ button. This operation will fast forward/backwards the CD so you can quickly find a particular passage in the track you are listening to (the CD is played slowly for a moment and then the playback speed increases). Locating a Track directly with the Remote Control -------------------- Using the number keys on the Remote Control allows you can go directly to the beginning of any track. s Using the Cassette Deck s 8 (Listening to a Tape) TAPE indicator/Analog clock (Display when using the Cassette Deck) § 1 ¡ PLAY The Cassette Deck allows you to play and record audio tapes. Notes: · The Cassette Deck performs best with normal tapes (metal or CrO2 tapes are not recommended). · The use of tapes longer than 120 minutes is not recommended, since characteristic deterioration may occur and these tapes easily jam in the pinch-roller and the capstan. 4. s Press the PLAY · · TAPE button. One Touch Play (AC power only) -- Just press the PLAY TAPE button on the Unit. The power is automatically turned on, "TAPE" is displayed, and if a tape is already in the deck, it will start to play. The tape is played and then stops when it reaches the end. The TAPE indicator turns to the right when the tape is travelling. To pause, press the 8 PAUSE button on the Unit. To cancel pause, press the 8 PAUSE button again. Play continues from the point where it was paused. To stop playing, press the § STOP/EJECT button. To remove the tape, stop the tape, and press the § STOP/ EJECT button again. Playback 1. s Press the § STOP/EJECT button to open the cassette holder. s Insert a cassette tape with the exposed side facing upward as shown below. + Forward direction To Fast-Forward and Rewind a Tape Press the 1 (fast-forward) button on the Unit to fast-forward the tape. Press the ¡ (rewind) button on the Unit to rewind the tape. · The Cassette Deck automatically stops when the tape reaches its end. 3. s Close the holder gently until it clicks. 7 s Using the Cassette Deck s REC indicator (Recording) TAPE indicator Analog clock 8 § 1 ¡ PLAY ¶ (Display when using the Cassette Deck) Things To Know Before You Start Recording -------------------------- s It should be noted that it may be unlawful to re-record pre-recorded tapes, records, or discs without the consent of the owner of copyright in the sound or video recording, broadcast or cable program and in any literary, dramatic, musical, or artistic work embodied therein. The correct recording level is automatically set by the ALC (Automatic Level Control) function, and is not affected by the VOLUME control on the Unit or by the use of sound effects. Two small tabs on the back of the cassette tape, one for side A and one for side B, can be removed to prevent accidental erasure or recording. [. . . ] If a CD is dirty, wipe it with a soft cloth in a straight line from center to edge. · · · · · · Do not store the tape: - In dusty places - In direct sunlight or heat - In damp areas - On a TV or speaker - Near a magnet Cassette Deck · If the heads, capstan, or pinch-roller in the Cassette Deck become dirty, you may experience: - Loss of sound quality - Discontinuous sound - Fading - Incomplete erasure - Difficulty recording Clean the heads, capstans, and pinch-rollers using a cotton swab moistened with alcohol. CAUTION: Do not use any solvent (for example, conventional record cleaner, spray thinner, benzine, etc. ) to clean a CD. Moisture Condensation Moisture may condense on the lens inside the Unit in the following cases: · After turning on heating in the room. · If the Unit is brought directly from a cold to a warm place. Should this occur, the Unit may malfunction. [. . . ]