User manual JVC RC-ST3SL

[. . . ] Disconnect the mains plug to shut the power off completely. The STANDBY/ON button in any position does not disconnect the mains line. Do not expose this appliance to rain or moisture. ) · Do not place any naked flame sources, such as lighted candles, on the apparatus. [. . . ] 5 Press and hold PROGRAM until the clock starts functioning. The unit has several preset EQ (equalizer) settings so that you can select one that most matches the type of music being played. Each time you press the button, the EQ setting changes as shown below. Do not turn off the unit with the volume set to an extremely high level; otherwise a sudden blast of sound might be produced damaging your hearing and/or the speakers, when you turn on the unit next time or start playing another source. You can enjoy powerful bass sound by turning on the Hyper-Bass Sound effect. No sound comes out of the speakers when headphones are connected. When the Hyper-Bass Sound effect is turned on, the HBS indicator lights up in the display window. Press the same button again so that the HBS indicator goes off. Turn down the volume before connecting headphones and keep the volume level low; as listening at high volumes could damage your hearing. Do not drive while listening through headphones. The unit can play audio CDs (8 cm and 12 cm) with the following mark. The following care should be taken to keep discs in good condition, since dirty, damaged or warped discs could lead to sound deterioration and damage the unit. Do not stick or write anything on both surfaces. Do not expose discs to direct sunlight, high temperatures from a heater, etc. After using a disc be sure to put it back in its case. To remove a disc from its storage case, press the center and lift the disc out. The unit can also play CD-R and CD-RW discs recorded in music CD format. User-edited CD-R (Recordable) and CD-RW (Rewritable) discs can be played only if they are already finalized. Some CD-R and CD-RW discs may not be played on the unit depending on the disc characteristics or recording conditions. Before playing CD-R or CD-RW discs, read their instructions and cautions carefully. Some CD-R and CD-RW discs may not be played on the unit because of damage or stain on them, or if the CD pickup lens is dirty. CD-RW discs may require a longer readout time (due to the fact that the reflectance of CD-RW discs is lower than that of regular CDs). [. . . ] Press the button again so that the MONO indicator goes off. 2 Tune to a station you want to preset using 4 or ¢. The station with the preset number is stored in the memory. 6 Repeat steps 2 to 5 to preset other stations, allocating a different preset number to each of them. [. . . ]