User manual JVC RX-558R

[. . . ] FM/MW/LW RECEIVER UKW/MW/LW-RECEIVER AMPLI/TUNER FM/PO/GO FM/MG/LG TUNER/VERSTERKER RECEPTOR FM/MW/LW RICEVITORE MF/OM/OL RX-558RBK CD TV VCR AUDIO TAPE/MD DELAY TEST SURROUND 1 FM/AM EFFECT 25 5 8 5 3 5 CENTER + 4 VCR 5 6 REARL + 7/P DVD SOUND CONTROL 9 MENU REARR + 10 DVD MULTI CD-DISC TV VOL. +10 ENT PHONO TV/VIDEO TV CH + RX-558R FM/MW/LW RECEIVER MASTER VOLUME ONE TOUCH OPERATION + STANDBY BASS BOOST ADJUST + + MUTING + VCR CH PTY SEARCH DISPLAY MODE VOLUME /I ECN STANDBY/ON TA/NEWS/INFO SETTING SLEEP PTY SEARCH MEMORY 8 4 1 PTY 7 DISPLAY + PTY 4 1 DVD MULTI DVD VCR FM SURROUND ONE TOUCH OPERATION RM-SR558RU REMOTE CONTROL SPEAKERS PHONES CD PHONO TAPE/MD AM INPUT ATT. 1 2 SOURCE NAME _ ON -- OFF ENHANCED COMPULINK CONTROL SYSTEM INSTRUCTIONS BEDIENUNGSANLEITUNG MANUEL D'INSTRUCTIONS GEBRUIKSAANWIJZING MANUAL DE INSTRUCCIONES ISTRUZIONI For Customer Use: Enter below the Model No. which are located either on the rear, bottom or side of the cabinet. Retain this information for future reference. Serial No. LVT0141-004A [E] Warnings, Cautions and Others/Warnung, Achtung und sonstige Hinweise/ Mises en garde, prcautions et indications diverses/Waarschuwingen, voorzorgen en andere mededelingen/Avisos, precauciones y otras notas/ Avvertenze e precauzioni da osservare Caution STANDBY/ON switch! [. . . ] Press FM or AM. The last station of the selected band is tuned in. The cursor control % / fi / @ / # buttons can be now used for operating the tuner. FM AM Using Preset Tuning Once a station is assigned to a channel number, the station can be quickly tuned. You can preset up to 30 FM and 15 AM (MW/LW) stations. In order to use the special functions available for RDS broadcasts, you need to preset the RDS stations. Both PTY Search and EON functions (see pages 15 and 16) are applicable only to preset stations. 2. Press cursor control % / fi repeatedly until "PRESET+" appears on the display. Press cursor control @ / # to select a preset channel station. Pressing @ decreases the preset channel number. Pressing # increases the preset channel number. To store the preset stations Before you start, remember. . . There is a time limit in doing the following steps. If the setting is canceled before you finish, start from step 1 again. From the remote control: 1. Press FM/AM. The last station is tuned in. Each time you press the button, the band alternates between FM and AM (MW/LW). FM/AM On the front panel ONLY: 1. Tune in the station you want to preset (see above). If you want to store the FM reception mode for this station, select the FM reception mode you want. See "Selecting the FM Reception Mode" on page 14. 2. Press the 10 keys to select a preset channel number. For channel number 5, press 5. For channel number 15, press +10 then 5. For channel number 20, press +10 then 10. For channel number 30, press +10, +10, then 10. DELAY TEST SURROUND 1 EFFECT 25 5 3 5 CENTER + 4 5 6 REARL + 7/P 8 2. Press MEMORY. "CH-" appears and the channel number position starts flashing on the display for about 5 seconds. MEMORY REARR + 10 Note: When you use the 10 keys on the remote control, be sure that they are activated for the tuner, not for the CD and others. Press cursor control @ / # to select a channel number while the channel number position is flashing. 13 5 9 MENU +10 ENT Selecting the FM Reception Mode When an FM stereo broadcast is hard to receive or noisy You can change the FM reception mode while receiving an FM broadcast. What Information Can RDS Signals Provide? You can see the RDS signals the station sends on the display. To show the RDS signals Press DISPLAY MODE on the front panel (or DISPLAY on the remote control) while listening to an FM station. PTY SEARCH DISPLAY MODE On the front panel ONLY: 1. Press FM. The last station of the selected band is tuned in. [. . . ] Speaker signal cables are not connected properly. Continuous hiss or buzzing during FM reception. Incoming signal is too weak. Select the correct source. Check speaker wiring and reconnect if necessary. [. . . ]