User manual JVC SP-XE5

[. . . ] Do read the operating instructions before you attempt to use the equipment. Do ensure that all electrical connections (including the mains plug, extension leads and interconnections between pieces of equipment) are properly made and in accordance with the manufacturer's instructions. Switch off and withdraw the mains plug when making or changing connections. [. . . ] DON'T listen to headphones at high volume as such use can permanently damage your hearing. DON'T obstruct the ventilation of the equipment, for example with curtains or soft furnishing. overheating will cause damage and shorten the life of the equipment. DON'T use makeshift stands and NEVER fix legs with wood screws -- to ensure complete safety always fit the manufacturer's approved stand or legs with the fixings provided according to the instructions. DON'T allow electrical equipment to be exposed to rain or moisture. ABOVE ALL ­ NEVER let anyone, especially children, push anything into holes, slots or any other opening in the case. ­ this could result in a fatal electrical shock; ­ NEVER guess or take chances with electrical equipment of any kind ­ it is better to be safe than sorry!Turn off the power to the amplifier before connecting the speaker system; otherwise, the speakers may be damaged. If this does not match with the speaker impedance range indicated on the amplifier, you cannot connect this system to the amplifier. Be sure to turn down the volume level on the amplifier to prevent unwanted noise before performing following operations: ­ Turning on or off other components ­ Operating the amplifier ­ Tuning FM stations ­ Fast-forwarding a tape ­ Continuously reproducing high frequency oscillation or high pitch electronic sounds ­ Connecting or disconnecting a microphone · When using a microphone, do not aim it at the speakers or use it near the speakers; otherwise, the howling which occurs may damage the speakers. ⷠBefore replacing the cartridge, always turn off the power both to the amplifier and to the turntable; otherwise, the clicking noise may damage the speakers. If cords are covered with insulation, twist the core of the cord at the end of each cord, then remove the insulation. Insert it into the hole while pressing down the terminal lever. Observe the tag attached to each cord, and use the appropriate cord for each speaker. [. . . ] Wait at least 30 minutes after the system is installed before turning on the TV's power. If another speaker system has been set up near the TV set, that system may cause color unevenness in the TV's picture. In spite of the shielded design of these speakers, some types of TVs may be affected by them. [. . . ]