User manual JVC TH-M303

[. . . ] DVD DIGITAL CINEMA SYSTEM Consists of XV-THM303, SP-PWM303, SP-THM303F, SP-THM303C and SP-THM303S INSTRUCTIONS LVT1147-003A [B] Warnings, Cautions and Others IMPORTANT for the U. K. DO NOT cut off the mains plug from this equipment. If the plug fitted is not suitable for the power points in your home or the cable is too short to reach a power point, then obtain an appropriate safety approved extension lead or consult your dealer. BE SURE to replace the fuse only with an identical approved type, as originally fitted. If nonetheless the mains plug is cut off ensure to remove the fuse and dispose of the plug immediately, to avoid a possible shock hazard by inadvertent connection to the mains supply. [. . . ] d: Lights when the LFE channel signal comes in. g: Lights when the surround left channel signal comes in. i: Lights when the surround right channel signal comes in. h: Lights when the monaural surround channel signal or 2 channel Dolby Surround signal comes in. The channel with " " shows that the corresponding speakers are reproducing the channels' sound. If the channels' sound decoded into 5. 1 channel is reproduced, only " " lights. The surround mode is turned on and the current surround mode appears on the display window. Each time you press the button, the surround mode changes. To turn off the surround mode Press SURROUND repeatedly until SURR OFF appears on the display window. Storing adjustments -- auto memory When you turn the power off, the system memorizes the current surround mode. The memorized mode is automatically recalled when you turn the power on. NOTE · When FM or AM is selected as the source, you cannot select any surround mode. · Note that the surround mode takes no effect on MPEG4 playback. · For a down-mixing prohibited DVD AUDIO disc, the system continues to output multi-channel signals with "MULTI CH" shown on the display window even if the surround mode is turned off during playback. On the other hand, the system outputs only the front left and front right channel signals with "LR ONLY" shown on the display window when you start playback with the surround mode having been set to "SURR OFF". Using the on-screen bar You can check disc information and you can use some functions using the on-screen bar. Showing the on-screen bar 7 Whenever a disc is loaded Selecting the surround mode The system is set up to automatically select the optimal surround mode for input signal from digital multichannel software. When playing back 2 channel source, you can select the desired surround mode manually. IMPORTANT Before using the remote control for the following operation; · Set the remote control mode selector to AUDIO. Press ON SCREEN. Each time you press the button, the on-screen bar changes as follows on the TV screen. 23 Advanced operations Example: During DVD VIDEO playback A B C D E F OFF (The on-screen bar disappears) (back to the beginning) See page 22 for button locations. G · The currently selected item shows green. 7 Contents of the on-screen bar during playback DVD VIDEO H I J K DVD AUDIO L M N O P VCD Q Shows disc type. Shows current transfer rate (Megabits per second). Shows current title (for DVD VIDEO) or group (for DVD AUDIO) number. Shows current chapter number (for DVD VIDEO) or track number (for other type of discs). See "Changing the time information" below. / : appears during fast forward/reverse. / : appears during playback in forward slow-motion/ reverse slow-motion. [. . . ] · Since the system may deteriorate in quality, become damaged or get its paint peeled off, be careful about the following. · DO NOT wipe it with a hard cloth. · DO NOT wipe it with thinner or benzine. · DO NOT apply any volatile substance such as insecticides to it. [. . . ]