User manual JVC THM303AS-TH-M303 Instruction Manual

[. . . ] DVD DIGITAL CINEMA SYSTEM Consists of XV-THM508, SP-PWM508, SP-THM508F, SP-THM508C and SP-THM505S Consists of XV-THM303, SP-PWM303, SP-THM303F, SP-THM303C and SP-THM303S INSTRUCTIONS LVT1147-010A [A, US, UN, UW, UG, UX] English Warnings, Cautions and Others CAUTION To reduce the risk of electrical shocks, fire, etc. : 1. Do not remove screws, covers or cabinet. Do not expose this appliance to rain or moisture. CAUTION -- F button!(XV-THM508/ XV-THM303) Disconnect the mains plug to shut the power off completely (the STANDBY lamp goes off). [. . . ] d: Lights when the LFE channel signal comes in. g: Lights when the surround left channel signal comes in. i: Lights when the surround right channel signal comes in. h: Lights when the monaural surround channel signal or 2 channel Dolby Surround signal comes in. The channel with " " shows that the corresponding speakers are reproducing the channels' sound. If the channels' sound decoded into 5. 1 channel is reproduced, only " " lights. The surround mode is turned on and the current surround mode appears on the display window. Each time you press the button, the surround mode changes. To turn off the surround mode Press SURROUND repeatedly until SURR OFF appears on the display window. Storing adjustments -- auto memory When you turn the power off, the system memorizes the current surround mode. The memorized mode is automatically recalled when you turn the power on. NOTE · When FM or AM is selected as the source, you cannot select any surround mode. · Note that the surround mode takes no effect on MPEG4 playback. · For a down-mixing prohibited DVD AUDIO disc, the system continues to output multi-channel signals with "MULTI CH" shown on the display window even if the surround mode is turned off during playback. On the other hand, the system outputs only the front left and front right channel signals with "LR ONLY" shown on the display window when you start playback with the surround mode having been set to "SURR OFF". Using the on-screen bar You can check disc information and you can use some functions using the on-screen bar. Showing the on-screen bar 7 Whenever a disc is loaded Selecting the surround mode The system is set up to automatically select the optimal surround mode for input signal from digital multichannel software. When playing back 2 channel source, you can select the desired surround mode manually. IMPORTANT Before using the remote control for the following operation; · Set the remote control mode selector to AUDIO. Press ON SCREEN. Each time you press the button, the on-screen bar changes as follows on the TV screen. Example: During DVD VIDEO playback OFF (The on-screen bar disappears) (back to the beginning) · The currently selected item shows green. 25 Advanced operations 7 Contents of the on-screen bar during playback DVD VIDEO See page 24 for button locations. DVD AUDIO VCD SVCD G Shows playback status. / : appears during fast forward/reverse. / : appears during playback in forward slow-motion/ reverse slow-motion. H Select this to change time information (F). See "Changing the time information" below. 33) J Select this for time search function. [. . . ] · DO NOT wipe it with thinner or benzine. · DO NOT apply any volatile substance such as insecticides to it. · DO NOT allow any rubber or plastic to remain in contact with it for a long time. Troubleshooting PROBLEM POSSIBLE CAUSE SOLUTION Power does not come on. No sound. The power cord and/or system cord is not connected. [. . . ]