User manual JVC TK-C210FW,TK-C215V4

[. . . ] DOME CAMERA TK-C210FW TK-C215V4 TK-C215V12 INSTRUCTIONS For Customer Use: Enter below the Serial No. Retain this information for future reference. TK-C210FW/TK-C215V4/TK-C215V12 Serial No. LST0308-001C Introduction Safety Precautions Information for Users on Disposal of Old Equipment [European Union] This symbol indicates that the electrical and electronic equipment should not be disposed as general household waste at its end-of-life. Instead, the product should be handed over to the applicable collection point for the recycling of electrical and electronic equipment for proper treatment, recovery and recycling in accordance with your national legislation. [. . . ] 25) D [POSITION SELECT] POSITION SELECT button Press this button to switch between the home and alarm positions. Display on the status indication LED C will change accordingly. 25) E [RESET/SPOT] RESET/SPOT button When this button is pressed, the value of the white balance or phase adjusted manually is reset to the default value. When the 2 [SELECT] switch is set to [WHT. BAL. ], the white balance is reset to the default value. When the switch is set to PHASE, the phase is reset to the default value. When setting to SPOT: When this button is pressed, white-spots are corrected. For instructions on correcting white-spots, see AWhite-spot correctionB (A pg. F [R/B, +/-] R/B, +/- adjustment button This button is pressed when manually adjusting the white balance or when adjusting the vertical phase of the line lock. The function of this button is selected using the 2 [SELECT] switch. When manually adjusting the white balance: Press the R button to increase the red tint and decrease the blue tint. Press the B button to increase the blue tint and decrease the red tint. When adjusting the phase: Press the + or - button to adjust the phase. Setting this switch to AONB automatically increases the sensitivity even when the brightness of the subject is insufficient. (Default setting: ON) FAR WIDE TELE NEAR RESET/[SPOT] IRIS R B 2. [SELECT] WHT. BAL. /PHASE setting switch. WHT. BAL. : The F [R/B, +/-] buttons are used as [R/B] adjustment buttons. PHASE: The F [R/B, +/-] buttons are used as [+/-] adjustment buttons. (Default setting: WHT. BAL. ) [SYNC] Synchronization system selection switch. This switch sets the synchronizing system for the camera. INT: This is set for internal synchronization LL (Line Lock): The camera's vertical synchronization is locked to the AC 24 V power line frequency. When switching between multiple cameras using a switcher, selecting this mode and adjusting the vertical phase can reduce the monitor sync disturbances occur that when the camera image is switched. U type: 60 Hz only E type: 50 Hz only (Default setting: INT) [WHT. BAL. ] ATW/MANUAL selection switch. For selecting whether to adjust the white balance automatically or manually. [. . . ] Remove the dome cover. White-spot correction As a general characteristic unique to CCDs, white-spots may appear on the screen with age. In order to reduce this phenomenon, this unit is equipped with a white-spot correction feature. Switch on the camera power supply and wait for at least 30 minutes. (Not available on TK-C210FW) TK-C215V4 2. [. . . ]