User manual JVC TK-C625

[. . . ] DOME TYPE CAMERA TK-C625 INSTRUCTIONS For Customer Use: Enter below the Model No. Retain this information for future reference. LWT0254-001A-H 2 EN Safety Precautions FOR USA AND CANADA INFORMATION FOR USA 8 INFORMATION This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. [. . . ] PAN KEY : Restores action set by the ARM. PATROL KEY : Restores action set by the ARM. 29) MEMO When using this feature, set the DIP SW4 at the back of RM-P2580 to AONB. OFF TIME Use this to set the time interval before performing Auto Return. [Set values: 1 min, 2 min, 3 min, 5 min, 10 min, 20 min, 30 min, 60 min] 1 min MEMO This item will be displayed as "- - -" when the AMODEB item is set to AOFFB and setting is not possible. 26 EN Setting Up the Camera Using RM-P2580 (continued) CAMERA TITLE/ALARM Screen Item CAM. AREA DISPLAY Function/Set Value Use this to specify the title that is always displayed at the bottom left of the screen. Specify up to a maximum of 16 characters. 35) AAREA DISPLAY Setup (DIRECTION)B (A pg. Equally divides the 360° panning range into 16 areas, and a title of up to 16 characters can be specified for each area. The corresponding area title specified will be displayed upon panning the camera manually. 35) Set N (North), which is the direction of the standard axis. When the camera is panned manually, the 360° panning range will be equally divided into 8 areas, each indicated by N, NE, E, SE, S, SW, W and NW respectively. 36) Use this to set the size of the title during an alarm. NORMAL: Same size as characters on the menu screen. DOUBLE DOUBLE: Double the size, both vertically and horizontally, of the characters on the menu screen. This is a screen for setting the title during an alarm. 37) These items are used to perform setting related to the alarm input terminals. For selecting the mode of the camera for which images are to be output when there is an alarm input. OFF : Does not output images even when there is an alarm input. HOME : Output images at the home position during an alarm input. POS1-99 : Output images at a selected preset position during an alarm input. MEMO Setting the AB&W MODEB (A pg. 27) item to AALARM INB switches the mode to the B&W mode and setting cannot be changed. Initial Value ^ OFF OFF TITLE ^ DIR ALARM TITLE SIZE ALARM TITLE EDIT. . [. . . ] (If the power cable(s) are too long or of an inadequate size, the correct voltage may not be supplied due to an increase in cable resistance during the pan/tilt operation. ) Remedy Use cable(s) with low cable resistance and of the correct cable length. (Ensure that the voltage supplied to the terminal board is correct during camera operation, i. e. when the rated current is flowing through the camera. ) Connect the cables properly. Change power cable(s) to one with of lower resistance (i. e. [. . . ]