User manual JVC TK-S215

[. . . ] Do not use attachments not recommended by the appliance manufacturer as they may cause hazards. Do not use this appliance near water - for example, near a bathtub, washbowl, kitchen sink, or laundry tub, in a wet basement, or near a swimming pool, etc. Do not place this appliance on an unstable cart, stand, or table. PORTABLE CART WARNING (symbol provided by RETAC) The appliance may fall, causing serious injury to a child or adult, and serious damage to the appliance. [. . . ] Set the lens to the maximum wide-angle position, and turn the back focus ring to adjust the focus. two or three times. ) Tighten the back focus locking screw by turning it clockwise ( ). 2. 4. 5. E-21 CONNECTION/INSTALLATION Auto white balance control adjustment Each light source has its own colour temperature. Therefore, when the main light source lighting an object is changed, the white balance should be adjusted again by pressing the AWC button. AWC button 1. 2. IRIS Place a white object under the same lighting condition as the object to be shot and zoom in to fill the screen with white. When the AWC button is pressed for approx. one sec. , the white balance is adjusted for the object being recorded. During the time when the Auto White function is operated, "AWC OPERATION" is displayed (for approx. When the appropriate white balance is acquired, "AWC OK" is displayed. Error message display NG : OBJECT Displayed when there is not enough white colour on an object or the colour temperature is not suitable. By taking a shot of a white object to fill the screen, adjust the white balance again. (50Hz power region only. ) When it is not set to LL, "---" will appear, disabling change the set value. [Set value: ­156 to 0 to 156] This adjusts the horizontal synchronization to those of other cameras and systems when a selector switch for the synchronizing system on the side is at INT/GL. When external signals are not input, "---" will appear, disabling change the set value. [Set values: ­16 to 0 to 16] Coarse adjustment of the SC phase in gen-lock operation. The SC phase can be varied by up to 90° in each direction. Adjust with reference to another camera (or system) and together with the SC FINE adjustment. Adjust SC COARSE and SC FINE only after adjusting H PHASE. When it is not set to GL, "---" will appear, disabling change the set value. [Set values: 0°, 90°, 180°, 270°] Fine adjustment of the SC phase in gen-lock operation. When it is not set to GL, "---" will appear, disabling change the set value. [Set values: 0 to 255] Initial value 0 H PHASE 0 SC COARSE 0° SC FINE 128 ALC SETTINGS Screen This makes automatic adjustments according to brightness. [. . . ] 5. Select MODE SELECT on the MAIN MENU screen. Press either the button or the button and select the AUX TERMINAL item. Press either the button or the button and set to "B&W OUT". Upon completion of setting, press the MENU button twice. [. . . ]