User manual JVC TM-H1700GE

[. . . ] COLOR VIDEO MONITOR ENGLISH A B BEDIENUNGSANLEITUNG : FARB-VIDEO-MONITOR MANUEL D'INSTRUCTIONS : MONITEUR VIDÉO COULEUR MANUALE DI ISTRUZIONI : MONITOR VIDEO A COLORI INSTRUCCIONES : MONITOR DE VIDEO A COLOR !"#$%&'(&) TM-H1900G TM-H1700G For Customer Use: Enter below the Serial No. which is located on the rear of the cabinet. Retain this information for future reference. Pour l'usage du client: Enter ci-dessous le numéro de série qui est situé sur l'arrière du coffret. [. . . ] COLOR SYSTEM RUSH DELAY ASPECT RATIO : : : : : : 00 LOWER 6500 AUTO STD. Press the MENU button. MENU 2 EXIT 3 4 The <MENU> screen is displayed. * The on-screen display goes off automatically after about five minutes with operation performed. CHROMA CONTRAST 2. Press the CHROMA/PHASE or CONTRAST/BRIGHT button to select MENU items. CHROMA CONTRAST VOLUME/SELECT MENU PHASE BRIGHT A selection mark (4) is put next to the selected item. Front panel button CHROMA/ PHASE CONTRAST/ BRIGHT Function displayed Contents Forward selection mark (4) Reverse selection mark (4) <Front panel buttons> 1 Selection mark (4): Indicates the menu item you select. PHASE BRIGHT 2 Menu item: Menu items you can 3 Setting display: Indicates the current settings (value). ADJ. COLOR SYSTEM RUSH DELAY ASPECT RATIO 4 Function display: The functions of the front panel buttons (5 buttons on the left) correspond to the function displayed. Function displayed Contents Forward the menu item. Press the VOLUME/SELECT buttons to set. VOLUME/SELECT Front panel button VOLUME/ SELECT (+) VOLUME/ SELECT (­) Function displayed + Contents Increase (to max. value) Forward the setting value Decrease (to min. value) Reverse the setting value Setting range 00 +01 ············ +39 +40 ­ + Lower the adjustment value. (to the minimum) Raise the adjustment value. (to the maximum) Forward the setting value. Exits the <MENU> screen. 4 ­ 1 4 1 EXIT Menu items SHARPNESS ADJ. BAR POSI COLOR TEMP. COLOR SYSTEM RUSH DELAY ASPECT RATIO Purpose Picture sharpness Volume bar position Color temperature of white balance Color system Delay value Aspect ratio LOWER 6500 AUTO STD. UPPER 9300 NTSC SLOW AUTO PAL Notes: When the screen aspect ratio is set to 16 - 9 (16:9) in ASPECT RATIO, the picture will be vertically reduced. RUSH DELAY sets the delay between the time the power switch is pressed and the time power is actually supplied to the monitor's circuits. : Power turns on approximately 1 second after the power switch is pressed. SLOW : Power turns on approximately 3 seconds after the power switch is pressed. * When turning on multiple ColorVideo Monitors simultaneously, it is recommended to use STD. or SLOW settings to reduce the rush current of the entire system. 4-3 16-9 * For normal use, leave the COLOR SYSTEM setting to AUTO. If reception is unsatisfactory in AUTO position, set it to the appropriate color system mode (NTSC or PAL). * When REMOTE SYSTEM is set to MAKE, and REMOTE ENABLE signal is short circuited (ON), "REMOTE" is displayed on the ASPECT RATIO setting menu, and Aspect ratio cannot be operated from the front panel. 4. If you want to set the other menu items, repeat procedures 2 and 3. [. . . ] Set COLOR SYSTEM in the <MENU> screen to AUTO. (See page 9. ) Set each picture control to the standard setting. (See page 7. ) Move the device away from the monitor and turn the monitor's power off. Wait at least 30 minutes, then turn the power on again. [. . . ]