User manual JVC UX-EP25

[. . . ] MICRO COMPONENT SYSTEM COMPACT COMPONENT SYSTEM UX-EP25 -- Consists of CA-UXEP25 and SP-UXEP25 INSTRUCTIONS LVT1598-003B [B] Warnings, Cautions and Others IMPORTANT for the U. K. DO NOT cut off the mains plug from this equipment. If the plug fitted is not suitable for the power points in your home or the cable is too short to reach a power point, then obtain an appropriate safety approved extension lead or consult your dealer. BE SURE to replace the fuse only with an identical approved type, as originally fitted. [. . . ] When you connect your iPod to the cable, make sure it connects all the way in. Do not carry the System with iPod connected. You might drop it down or it might cause damages to the connector part. 2 1 You can place the iPod on the supplied iPod stand. 12 When disconnecting the iPod, make sure that the System is turned off. To remove the connector from your iPod, squeeze the buttons on the sides and pull. Always set volume to "VOLUME MIN" when connecting or disconnecting the other equipment. Connect the USB mass stotrage class device directly to the system. Using a USB hub may result in malfunction. Coded or encrypted tracks in a special method cannot be played on the unit. The USB mass storage device's battery is charged while the System is turned on. IMPORTANT To playback sounds on the iPod To start: To pause: To connect the USB mass storage class device When connecting a USB mass storage class device, refer also to its manual. or DAP To select a track Decrease the track numbers Increase the track numbers When disconnecting the USB mass storage class device, make sure that the System is in the stop condition. To playback sounds on the USB mass storage class device IMPORTANT Search. . . An iPod does not play on the USB MEMORY terminal. "RESTRICT" appears on the display when an iPod is connected to the USB MEMORY terminal while USB MEMORY is selected for the source. To start: To stop: Playing Back from the USB mass storage class device This System is equipped with a USB MEMORY terminal on the front panel. You can connect a USB mass storage class device such as a USB flash memory device, Digital Audio Player (DAP), etc. to this System. This System cannot recognize a USB mass storage class device whose rating exceeds 5V/500mA. Remember you cannot send any data to your USB mass storage class device from this System. The USB MEMORY lamp on the left of the USB MEMORY terminal flashes while USB MEMORY is selected for the source. 13 To select a track/group* Decrease the track/group* numbers. Increase the track/group* numbers. For MP3/WMA playback According to the MP3/WMA playback mode, 4 / or number buttons work for the group selection or the track selection. Examples: When the MP3 play back mode is "GROUP. " Total group number * For details about the group selection, see "For MP3/WMA playback" on this page. GROUP mode Total track number You can change the MP3/WMA playback mode by pressing MP3/ WMA PLAY MODE. Each time you press the button, the MP3/WMA playback mode changes as follows: TRACK MODE GROUP MODE TRACK: 4 / , and number buttons work for the track selection of the MP3/WMA. GROUP: 4 / , and number buttons work for the group selection of the MP3/WMA. MP3/WMA groups/tracks configuration This System plays back MP3/WMA tracks as follows. The play order in the figure is for MP3/WMA tracks on the disc. MP3/WMA tracks on USB mass storage class device may be played back differently. Level 1 Level 2 Hierarchy Level 3 Level 4 Level 5 Group with its play order MP3/WMA track with its play order 14 Resume Play for MP3/WMA If you press 7 while playing MP3/WMA, the number of the track where you have stopped playback will be memorized by the unit. By pressing CD 6 or USB MEMORY 6, you can start playback again from the beginning of the same track. 2 Select USB AUDIO for the source. To activate/cancel resume play Remote ONLY FM USB AUDIO AM AUX 3 Connect the System to the PC using a USB cable (not supplied). (rear panel) USB cable PC RESUME ON RESUME OFF memo Pressing OPEN/CLOSE (for Disc), or disconnecting the USB mass storage class device will erase the track number for resume play. To play back from the first track while resume play is activated, press 7 twice during playback. Use "USB series A plug to B plug" cable. 4 The USB drivers are installed automatically. Playing Back from the PC This System is equipped with a USB terminal on the rear panel. You can connect your PC to this terminal and enjoy the sound out of your PC. [. . . ] The built-in microprocessor may malfunction due to external electrical interference. Unplug the AC power cord and then plug it back in. Unable to operate the System from the remote control. The path between the remote control and the remote sensor on the System is blocked. [. . . ]