User manual JVC UX-N1S

[. . . ] IMPORTANT for the U. K. DO NOT cut off the mains plug from this equipment. If the plug fitted is not suitable for the power points in your home or the cable is too short to reach a power point, then obtain an appropriate safety approved extension lead or consult your dealer. BE SURE to replace the fuse only with an identical approved type, as originally fitted. If nonetheless the mains plug is cut off ensure to remove the fuse and dispose of the plug immediately, to avoid a possible shock hazard by inadvertent connection to the mains supply. [. . . ] · Press repeatedly to change the frequency step by step. Press to select a preset number for the station you store. · For presetting stations, see below. The MONO indicator appears on the display. Reception will improve though the stereo effect is lost. To restore the stereo effect, press again. Setting the Clock and Daily Timer Receiving FM Stations with Radio Data System Radio Data System allows FM stations to send an additional signal along with their regular program signals. With the System, you can receive the following types of Radio Data System signals. PS (Program Service): Shows commonly known station names. PTY (Program Type): Shows types of broadcast programs. RT (Radio Text): Shows text messages the station sends. Enhanced Other Networks: Provides the information about the types of the programs broadcast by the Radio Data System stations of the different networks. NOTE If you want to know more about Radio Data System, visit <http://www. rds. org. uk>. Learning More about This System Basic and Common Operations (see page 3) · Sound adjustments also affect the sound through the headphones. · Sound adjustments do not affect recording to the external device. · You can set the clock and daily timer while the SAVE mode is turned on. While setting the clock or daily timer, the display is turning on. Playing Back Discs (see pages 4) · This System cannot play "packet write" discs. ­ MP3 discs are required a longer readout time than regular CDs. (It depends on the complexity of the group/file configuration. ) ­ Some MP3 files cannot be played back and will be skipped. This result from their recording processes and conditions. ­ When making MP3 discs, use ISO 9660 Level 1 or Level 2 for the disc format. ­ This System can play back MP3 files with the extension code <. mp3> (regardless of the letter case--upper/ lower). ­ It is recommended that you make each MP3 file at a sampling rate of 44. 1 kHz and at bit rate of 128 kbps. [. . . ] \ The FM antenna is not properly extended and positioned. 1 2 3 "LINE" appears on the main display. Adjust the volume level to the level you want to listen to. To Play Back a Portable Audio Device Easily By using QP Link (Quick Portable Link), you can easily start playing back a portable audio device connected to the LINE IN jack. On the remote Press and hold for more than 2 seconds 1 2 Start recording or standby recording on the device. or Start playing the CD or tune into the station you want to recording. DON'T continue to operate the equipment if you are in any doubt about it working normally, or if it is damaged in any way--switch off, withdraw the mains plug and consult your dealer. Specifications Specifications and appearance are subject to change without prior notice. Amplifier section OUTPUT POWER: 10 W (5 W + 5 W) at 4 (10% THD) Speakers/Impedance: 4 ­ 16 Audio Input LINE IN: 500 mV/47 k (at "LINE IN LVL1") 250 mV/47 k (at "LINE IN LVL2") 125 mV/47 k (at "LINE IN LVL3") Audio Output LINE OUT: 1. 0 Vrms (10 k) (at "LINE OUT LVL1") 2. 0 Vrms (10 k) (at "LINE OUT LVL2") DON'T remove any fixed cover as this may expose dangerous voltages. [. . . ]