User manual JVC UX-N1W

[. . . ] Mains (AC) Line Instruction (not applicable for Europe, U. S. A. , Canada, Australia, Hong Kong and U. K. ) MICRO COMPONENT SYSTEM UX-N1S Adjusting the voltage selector Use a screwdriver to slide the voltage marker so that it is set to the same voltage as where you are plugging in the unit. Bottom of the unit CAUTION: Proper Ventilation To avoid risk of electric shock and fire, and to prevent damage, locate the apparatus as follows: 1. Front: No obstructions and open spacing. Sides/ Top/ Back: No obstructions should be placed in the areas shown by the dimensions below. Maintain an adequate air path for ventilation by placing on a stand with a height of 10 cm or more. [. . . ] · While playback is stopped, total track number and total playing time (for MP3 disc, group number and track number) appear on the main display. Increases the track numbers. Press while playback is stopped. Press twice while playback is stopped to exit from the program play. · The stored program is erased. For better FM/AM reception 2 Insert 3 Release Stop playback Outdoor FM antenna (not supplied) PHONES RIGHT SPEAKERS LEFT COAXIAL ANTENNA Disconnect the supplied FM antenna, and connect to an outdoor FM antenna using a 75 wire with coaxial type connector. Select a track Decreases the track numbers. Increases the group numbers while playback is stopped. Decreases the group numbers while playback is stopped. Fast-forwards the track by pressing briefly. Press and hold ¢ UP, then press when the System is on standby. Each time you press the button, the band alternates between FM and AM. · "FM" or "AM" and selected frequency appear on the main display. · If an FM program is broadcast in stereo, the ST (stereo) indicator lights up on the display (only when the reception is good). The System starts searching for stations and stops when a station of sufficient signal strength is tuned in. · Press during searching to stop. · Press repeatedly to change the frequency step by step. Press to select a preset number for the station you store. · For presetting stations, see below. The MONO indicator appears on the display. Reception will improve though the stereo effect is lost. To restore the stereo effect, press again. Setting the Clock and Daily Timer Setting the Clock Without setting the built-in clock, you cannot use Daily Timer and Sleep Timer. Press to activate the clock setting mode. · If you have already adjusted the clock before, press the button repeatedly until the clock setting mode is selected. or Adjust the hour, then the minute. Learning More about This System Basic and Common Operations (see page 3) · Sound adjustments also affect the sound through the headphones. [. . . ] NOTE If an external device is not equipped with a stereo mini plug audio output, use a plug adaptor to convert the stereo mini plug to the corresponding plug of the audio output. Maintenance To get the best performance of the System, keep your discs and mechanism clean. Handling discs · Remove the disc from its case by holding it at the edge while pressing the center hole lightly. · Do not touch the shiny surface of the disc, or bend the disc. · Put the disc back in its case after use. [. . . ]