User manual JVC UX-T550

[. . . ] UX-T550 INSTRUCTIONS For Customer Use: Enter below the Model No. which are located either on the rear, bottom or side of the cabinet. Retain this information for future reference. Serial No. GNT0001-001A [B] NEDERLANDS ESPAÑOL DEUTSCH MICRO COMPONENT SYSTEM ENGLISH Caution ­ switch! REPRODUCTION OF LABELS AND THEIR LOCATION Disconnect the mains plug to shut the power off completely. [. . . ] First press this button to set the 10's digit, then press the track number button to set the 1's digit. To skip to another track during play When the required track number button is pressed, the display shows the designated track number and play starts from the beginning of the designated track. 8 Programmed play (using the remote control unit) Up to 20 tracks can be programmed to be played in any required order. The total playing time of programmed tracks is displayed (up to 99 minutes, 59 seconds). (Example: When programming the 2nd track to be played first, and the 6th track next, then the 12th track, etc. ) ~ CD Y ! / 2 PROGRAM To designate the 2nd track. 2 PROGRAM PROGRAM @ 6 To designate the 12th track. ¤ CD +10 2 2 6 2 6 12 PROGRAM PROGRAM The 12th track The total playback time of programmed tracks is displayed. ~ Press the CD 3/8 button to set to the CD mode. Press the PROGRAM button to set to the programming mode. Press the PROGRAM button; the tracks making up the program will be displayed in programmed order. Track number / Press to designate the required track number. @ Designate the remaining tracks by pressing the track number buttons. ¤ Press the 3/8 button when programming is completed. During programmed play, press this button twice. When the CD holder is opened, programmed tracks are cleared automatically. Notes: If the total playing time of the programmed tracks exceeds 99 minutes 59 seconds, the total playing time indication will go out. When programming a track number higher than 21 on a disc containing more than 21 tracks, the total playback time of all the programmed tracks will not be displayed. When a disc with 16 or more tracks is loaded, the "OVER" indicator will appear. PROGRAM 2 PROGRAM Program order number Repeat play (using the remote control unit) Press the REPEAT button before or during play. A single track or all the tracks can be repeated. Whether a single track or all tracks are to be repeated can be specified. Each time the REPEAT button is pressed, the mode will change from a single track ( ), to all the tracks ( ALL), to the clear mode, in this order. Single track repeat ( ) The current or specified track will be played repeatedly. All tracks repeat ( ALL) All tracks or the programmed tracks of a CD will be played repeatedly. Random play (using the remote control unit) Press the RANDOM button, and all tracks on a CD play once in random order. REPEAT ALL Single track All tracks RANDOM Goes off. Repeat playback is released. 9 HANDLING CASSETTE TAPES Cassette tapes 1. Using a pencil or like object, gently tighten the tape as shown. To prevent recordings from being erased accidentally, remove the tab(s) with a screwdriver, etc. Reseal the slots with adhesive tape to erase and re-record after the tabs have been removed. [. . . ] (When demagbutton should be set to STANDBY. ) netizing the head, the 2. Do not use anything other than alcohol for cleaning. Thinner and benzine will damage the rubber pinch roller. Cleaning the lens If the lens in the CD pickup is dirty, dropout, etc. , could degrade sound. [. . . ]