User manual JVC WR-DVP3U

[. . . ] Before mounting the camera inside the marine case, dive with only the empty marine case and test for water leaks. Allow 5 or 6 minutes to ensure there are no leaks. Be sure to perform this test to ensure the safety of your camera. The following are some common causes of water leaks: A. [. . . ] There is sand, dirt, hair or other foreign matter on the O-ring. There is sand, dirt, hair or other foreign matter on the contact surface of the O-ring or on the inside of the lid. The provided strap or silica gel bag is pinched inside the marine case when the lid is closed. Check that there are no scratches or cracks on the marine case every time you use it. The marine case must withstand water pressure with use. Repeated exposure to pressure eventully leads to material fatigue, which may result in damage of the marine case. Every time you use the marine case, check in advance that there are no scratches or cracks. If you frequently use the marine case, be sure to ask for maintenance at the store of purchase. ) To protect your camera and ensure optimum use, keep the examples listed above in mind when using the marine case. JVC accepts no responsibility for water leakage or damage to anything inside the marine case (camera, SD card, etc. Always have someone hold the marine case for · if for any reason water leakage occurs , remove You when diving into, or getting out of water. When you have finished recording, rotate the power/mode switch lever to turn the camera's power off. Pull the marine case power/mode switch lever to release the lock, and switch on the camera's power. Sometimes, due to sudden shaking or impact to the marine case, the camera's drop detection function operates to switch off the camera's power. Always perform maintenance on the marine case after you have finished recording. Failing to perform maintenance on the marine case will allow dirt to build up on the case, causing water leaks. If you do not intend to use the marine case for longer than 1 month, remove the O-ring from the marine case, and spread a thin layer of the supplied silicone grease over the entire O-ring. After that, place the O-ring inside a clean plastic bag, and store it in the maintenance kit case. Replace the O-ring with a brand new one every year. Wash the marine case in water while it is still sealed. [. . . ] Recommend submerging the marine case in fresh water for a while to remove salt. Move the buttons and levers while the marine case is submerged, and rinse the salt out from any gaps or grooves etc. When re-using an O-ring after storage, always Wipe off the water with a dry cloth, and allow the marine case to completely dry out. Maximum pressure Remove Operations Water depth up to 30 meters Power on/off Video recording start/stop Still image shooting Zoom (telephoto/wide angle) +400 g (with the camera inserted and the supplied battery pack attached) 233 mm x 172 mm x 132 mm Approx. [. . . ]