User manual JVC WR-MG88U

[. . . ] Always wash the marine case in fresh water after use. If water leaks into the case due to careless use of the marine case, JVC cannot accept responsibility for any damage that may occur to the internal equipment and materials (video camera, SD card etc), or any expenses incurred in taking the photographs/video. Therefore, please be careful when using the marine case. Be sure to perform the following pre-use test before diving. [. . . ] JVC accepts no responsibility for water leakage or damage to anything inside the marine case (camera, SD card, etc. ) due to careless usage of this product. Be sure to follow correct procedures when using the marine case. The attachment base differs depending on the model of camera that you have. Commercially available lights and weights can also be attached. Screw tightening key · You can purchase the following set of expendable parts. Apply 2 or 3 drops of the glass cleaner provided onto one of the lens tissues or a clean cloth, and wipe the inner side of the marine case front glass. Using the supplied pick, remove the O-ring from the main case. Still image shooting button Video recording start/stop button Power/mode switch lever: Turns camera's power on/off, or switches video or still mode. Close the empty marine case (no camera inside). Inserting the provided silica gel between the camera and marine case prevents the inside of the marine case from steaming up. Pull the power/mode switch lever of the marine case in the direction of the arrow ( ), and rotate it to lock it ( ). If the power/mode switch lever is not locked, it may touch or damage the camera when the camera is put into the case. Base attachment groove Base Marine case internal base For cameras that are equipped with Base A, attach the lens hood. Attach the base in the correct way for your model of camera. Line up the tripod screw hole on the base of Your camera with the base holes of the case, and tighten the screw. If it is difficult to open buckles, use the buckle opener. The risk of water leakage is extremely high if the O-ring is twisted, if you forget to attach it, or if something is trapped in the seal. Before recording Submerge the marine case with the camera equipped into a bathtub or water tank full of fresh water. Always have someone hold the marine case for · if for any reason water leakage occurs , remove You when diving into, or getting out of water. [. . . ] Remove the O-ring, and wipe off any salt, sand, and any other debris. Also wipe the groove in which the O-ring was inserted, and the part of the marine case that was in contact with the O-ring, and allow them to dry. Buoyancy Main unit dimensions (W x D x H) Main unit weight Wipe the inside of the marine case with a dry cloth. Drop a few drops of the cleaning fluid onto the inside of the front glass, and wipe it off using the silicone cloth etc. [. . . ]