User manual JVC XV-S40BK

[. . . ] DVD VIDEO PLAYER XV-S40BK/XV-S42SL XV-E100SL Introduction 2 Preliminary knowledge 5 Getting started 13 Basic operations 17 OPEN /CLOSE STANDBY/ON PLAY MODE 3D PHONIC CANCEL RETURN Advanced operations 20 1 4 7 10 2 5 8 0 3 6 9 +10 THEATER POSITION ANGLE SUBTITLE AUDIO DIGEST ZOOM PREVIOU S 4 7 ¢ SELECT NEXT CLEAR 3 STROBE 8 SLOW+ SLOW­ 1 E ¡ TITL MEN U DVD/CD PLAYER STANDBY Initial settings OPEN/CLOSE 35 5 5 5 ENTER CH OIC E DISP LAY STANDBY ON 0 4 DOLBY DIGITAL DVD/VIDEO CD/CD SKIP ¢ STOP PLAY PAUSE 7 3 8 RM-SXVB40A REMOTE CONTROL Additional information 42 INSTRUCTIONS For Customer Use: Enter below the Model No. which are located on the rear, bottom or side of the cabinet. Retain this information for future reference. Serial No LET0178-005A [B] Warnings, Cautions and Others IMPORTANT for the U. K. [. . . ] With the digital connection, the units settings for COMPRESSION and DOWN MIX in the AUDIO page of the preference display are invalid. Settings for these items must be made from the decoder . See # Getting started Getting started To connect the power cord When all the audio/video connections have been made, insert the smaller plug of the supplied AC power cord to the units AC IN connector, then insert the other end to the wall outlet. Make sure that plugs are inserted firmly. The STANDBY indicator lights and setup is completed. Warning Disconnect the power cord if you are not going to use the unit for a long time. Disconnect the power cord before cleaning the unit. Disconnect the power cord before moving the unit. Do not connect or disconnect the power cord with wet hands. Do not pull the power cord when disconnecting it, as this may damage the cord and cause fire, electric shock, or other accidents. Warning Do not damage, alter, twist, or pull the power cord, as this may cause fire, electric shock, or other accidents. T prevent any accidents or damages caused by an unsuitable AC power cord, only use the supplied power cord. If the o cord is damaged, contact a dealer and get the new power cord. Do not put anything heavy, or the unit, on the power cord, as this may cause fire, electric shock, or other accidents. Getting started To install batteries in the remote control unit The battery compartment is located on the back of the remote control unit. Press down on the point shown by the arrow at the top of the compartment cover, and pull up the cover to open the compartment. Place the two accessory R6P (SUM-3)/AA(15F) batteries in the remote control according to the polarity markings (+ and ) inside the compartment and on the batteries. ! Place the cover over the compartment, and press down lightly. The batteries will last about six months with normal use. If the functions of the remote control become erratic, replace the batteries. See below for more information. Precautions for the safe use of batteries Observe the following precautions for the safe use of batteries. If they are used improperly their life will be shortened, they may burst or their contents may leak. Precaution Remove the batteries from the remote control if it is not going to be used for a long period of time. Remove dead batteries and dispose of them properly. Never leave dead batteries lying around, take them apart, mix them with other refuse, or throw them into an incinerator. Never touch liquid that has leaked out of a battery. Do not mix new and old batteries, or batteries of different types, when replacing them. $ Basic operations In the following description, the buttons on the remote control unit are mainly used, however, you may use the corresponding buttons on the front panel of the unit if available. English English English Turning on/off the unit Press STANDBY/ON on the remote control unit or press on the front panel. DVD/CD PLAYER STANDBY OPEN/CLOSE OPEN /CLOSE STANDBY/ON STANDBY ON 0 4 DOLBY DIGITAL DVD/VIDEO CD/CD PLAY MODE 3D PHONIC CANCEL RETURN STANDBY/ON SKIP ¢ STOP PLAY PAUSE 7 3 8 1 4 7 10 2 5 8 0 3 6 9 +10 THEATER You can turn on the unit by pressing the operation, the unit starts playback if the disc is set in the disc tray. If no disc is set, NO DISC appears on the display window. You can turn on the unit by pressing the button on the front panel. ! button. In this (OPEN/CLOSE) Even if you press the STANDBY/ON or button to turn off the unit, the unit is not disconnected from the AC power source as long as it is connected to the wall outlet. [. . . ] (See page 12. ) Picture is not normal when using the S-VIDEO jack. The unit is set to feed the RGB signals (instead of the S-video signals). Make the unit feed the S-video signals (See page 14). Picture is noisy. The unit is connected to a VCR directly and the copyguard function is activated. Connect the unit so that the picture signal flows directly to the TV. Connection is incorrect. Input selection of amplifier is incorrect. Check the connections. Select correctly. No audio is reproduced when playing back a DVD disc recorded with 96kHz, linear PCM audio. The audio signal is derived from the unit's DIGITAL OUT . Use the AUDIO OUT when playing back such discs. Sound is distorted or noise is generated. Disc is dirty. Wipe the disc surface. Picture does not fit the television screen. MONITOR TYPE is not correctly set. Select monitor type correctly. (See page 37 . ) Television is not correctly set. Set the television correctly. Microcomputer malfunction due to lightning or static electricity. Operation is not possible. Turn off the power and unplug the power cord, then connect the power cord again. Moisture condensation caused by a sudden change of temperature or humidity. Turn off the power, then turn it on a few hours later. "! Additional information Additional information Specifications General Readable discs: Video format: DVD VIDEO, Audio CD, Video CD PAL Other Power requirements: Power consumption: Mass: Dimensions (W x H x D): AC 230V , 50Hz 16 W (POWER ON), 2. 7 W (STANDBY mode) 2. 6 kg (5. 8 lbs) 435 mm x 68 mm x 267 mm . 5 (17-3/16 inch x 2-11/16 inch x 10-9/16 inch) Video outputs VIDEO OUT (pin jack): S-VIDEO OUT (S jack): RGB out: Horizontal resolution: 1. 0 Vp-p (75 :) Y Output: C Output: O-700 mV (75 : 500 Lines 1. 0 Vp-p (75 :) 286 mVp-p (75 :) Audio outputs ANALOG OUT (pin jack): DIGITAL OUT: (COAXIAL): (OPTICAL): 2. 0 Vrms (10 k :) 0. 5 Vp-p (75 : termination) 21 dBm to 15 dBm (Peak) Audio characteristics Frequency response: CD DVD DVD Dynamic range: (sampling frequency 44. 1 kHz): (sampling frequency 48 kHz): (sampling frequency 96 kHz): 2 Hz to 20 kHz 2 Hz to 22 kHz 2 Hz to 44 kHz 16 bit: More than 98 dB 20 bit: More than 106 dB 24 bit: More than 106 dB Wow and flutter: Total harmonic distortion: Unmeasurable (less than ± 0. 002%) Less than 0. 002% * Specifications and appearance subject to change without prior notice. Appendix A:Table of languages and their abbreviations When you select the subtitle language or sound, the languages shown below are displayed as abbreviations. [. . . ]