User manual JWIN JG-MRS42

[. . . ] You can find the forms on line at: http://www. fcc. gov/formpage. html, or call 1 -800-4183676. Reorient or relocate the receiving antenna. Increase the separation between the equipment and receiver. Connect the equipment into an outlet on a circuit different from that to which the receiver is needed. [. . . ] Press and hold the push-to-talk button, and speak gently into the microphone about 3 inches away from the radio. Release the push-to-talk button when finished transmission. Turn the radio on 1. The radio will beep and the LCD displays ready saved channel settings. Transmitting a Call Tone 1. Press and hold Call/EMG button till the TX LED lights up in red, and the LCD displays CALL. This GMRS radio has 5 different Call Tones. Please refer to Menu chapter to set different Call Tone. (8) override other transceivers of same channel. Please keep it Lo (Low) at channel 1 through 7. Emergency channel indicator EMG (Emergency) 1. Press and release Call/EMG button when you are in an emergency situation. You may speak into the radio, or transmit an emergency Call Tone for instant HELP. Press and release the Call/EMG button again to exit. Note: The maximum transmission range will vary depending on terrain and environment. Range will be greater in open fields, while the range is shorter within/around buildings or large structures. Illuminating the Display 1. Press Lamp button to illuminate the LCD when in the darkness. The LCD is illuminated for 5 seconds unless Lamp button is pressed again. (9) (10) (11) (12) (13) (14) LCD icons (1) (2) (3) (4) (5) (6) (7) Active Channel number Active CTCSS channel number RSSI (Receiving signal strength indicator) Automatic Power saver indicator Roger beep indicator Scanning indicator Transmitter power indicator: Keep transmitter power Hi (High) if receiving party is far beyond 2 miles. U nless otherwise keep it Lo (Low) all the way, or your radio may Figure 3: LCD display & icons VOX (Voice activated transmission) Battery status indicator Keypad lock indicator Keystroke tone indicator Receiving indicator Transmission indicator Special Features Automatic Squelch Your GMRS is equipped with automatic squelch circuitry, which filters out weak transmission and unwanted noise. These signals may be picked up as background static, and are usually caused by terrain conditions, or if you have reached the limit of your range. Automatic Power Saver Monitor This feature turns off the Automatic Squelch feature momentarily. This allows your unit to receive all signals to its maximum range, but it may pick up static signals as well. You can set the speaker volume by the noise of the static. To activate this, press the Monitor button for up to 0. 5 seconds. To restore the automatic squelch, release the Monitor button. [. . . ] jWIN will not be responsible for delays or unprocessed claims resulting from a purchaser's failure to provide any or all of the necessary information. Send all inquiries or returns to: Customer Service Dept. jWIN Electronics Corp. , 51-41 59th Place, Woodside, N. Y. 11377 There are no express warranties except as listed above. [. . . ]