User manual JWIN JL-CD811

[. . . ] Reversed batteries may cause damage to the device. If the device is not to be used for a long period of time, remove the batteries to prevent injury from possible battery leakage. LISTENING TO THE RADIO OPERATION m m m m ANTENNA For FM reception there is a built-in one-meter FM aerial wire at the rear of the unit. Unravel the wire and move it around to obtain the best reception. For MW reception the signals are picked up through the built-in ferrite antenna. [. . . ] Push down in the centre until disc is locked in place. Close the disc compartment by pressing the ]PUSH OPEN/CLOSE^. When the compartment is fully closed, the disc will start turning automatically. The total number of tracks will appear in the display. The disc compartment may be opened at any time by first pressing the stop button and then pressing the ]PUSH OPEN/CLOSE^. Remove the CD only after the compartment has fully opened. m CAUTION Do not put anything except a compact disc into the compartment. Foreign objects can damage the mechanism. Keep the disc compartment closed when not in use to prevent dirt and dust from entering the mechanism. Never place more than one disc into the disc compartment at any time. If the disc is correctly loaded, the total number of tracks on the disc will be displayed: Notes: After the disc compartment is fully closed, the disc information may not appear on the display. This means that the disc is improperly loaded (most likely it is upside down). If the REPEAT button is pressed 1 more time during play, the REPEAT indicator will go off, Repeat Mode will end and normal playback will resume from that point. REPEAT PLAY O F ALL THE TRACKS m m m m 5 PROGRAMMED DISC PLAY m m m Insert a CD as described in the previous section and close the disc compartment. Silide the FUNCTION switch to the CD position. Press the PROGRAM button, ]P 01^ will show on the display, select the first track to be played back using the SKIP forward/backward buttons, then press the PROGRAM button again. Repeat this step to program additional tracks up to a maximum of 20 tracks. Press the PLAY/PAUSE button to begin Program playback and adjust the VOLUME control as desired. To skip forward or backward through the programs, press the SKIP buttons. When the disc is through playing, it will stop. m m m m Notes: - Press the STOP button to stop the program before it is finished. - To clear the memorized tracks, press the PROGRAM button to enter the Program mode (PROGRAM indicator will blink) and then press STOP button or open the CD door as explained. - Programming is the ability to select the order in which a series of tracks will be played. - Each track may be stored in the program memory as many times as desired (up to 20 tracks). - To repeatedly play the memorized tracks, press the REPEAT button twice; the REPEAT indicator will light. CLOCK SETTING TO SET m m TO SET m m m m OR RESET THE ACTUAL TIME To set the minute: Press and hold the CLOCK ADJ button, then press the SKIP 9/M button until the present minute appears in the display. [. . . ] Press the SLEEP button and ] - - ] will appear on the clock display. Repeatedly press the SLEEP button for the desired sleep time of 90, 60 or 30 minutes. The SLEEP indicator will light to indicate the Sleep mode is activated. The sleep time will internally count down and then turn off when the desired amount of time has passed. m To turn the Sleep mode off, either press the STANDBY/ON button, which will turn the unit off, or press the SLEEP button until ] - - ] appears on the display to keep the radio/CD on, but cancel the Sleep mode. HEADPHONE Headphones should have a 3. 5mm diameter stereo plug and an impedance of 8-32 ohms. [. . . ]