User manual JWIN JT-P870

[. . . ] jWIN jWIN Electronics Corporation digital generation JT-P870 OWNER'S MANUAL and OPERATING INSTRUCTIONS 12/19/2003 8:34 AM 1 TABLE OF CONTENTS FEATURES. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 3 Diagram. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 4 Easy Set Up. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 5 SETTINGS. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . [. . . ] Finally the telephone will display `Set Minute'. After the settings are complete, press the [TIME] button once and the telephone will announce the time. Note: If you don't press any keys within 8 seconds after entering the time setting, the telephone will exit setting mode automatically. LCD Contrast After the Time/Date Setting, you will be prompted to enter the LCD Contrast Setting: 1. Press the [UP] and [DOWN] buttons to adjust the LCD contrast. There are eight levels for contrast adjustment. Press [DEL] to confirm and exit settings. Ringer HI / LO / OFF Selection To adjust the volume of your ringer on your phone: 1. Slide the [RINGER] switch to `HI' position or `LO' position according to your preference. Slide the [RINGER] switch to the `OFF' position to turn the ringer off. The ringer will not be activated by any incoming calls. Tone / Pulse Selection Select the dialing mode that your telephone requires by sliding the [T-P] switch to either: `T' position for tone dialing, or to `P' position for pulse dial. Note: While in pulse dial status, press `' to change to tone dial. Speakerphone and Receiver Volume Adjustment These volume switches are located on the sides of the phone base. The receiver volume is on the left and the speaker volume switch is on the right. - Pick up the receiver and slide the [VOLUME] switch to adjust the receiver volume. The switch slides from MIN (lowest volume) to MAX. Adjust according to your preference or need. Answer (Recording) On / Off Setting - The default Answer (recording) state is `On', Press [ANSWER] once and the telephone will display `Answer Off'. Press [Answer] again; the telephone will display `Answer On'. Note: If you wish to enable incoming callers to leave a message, you must set the ANSWER function to `On'. 12/19/2003 8:34 AM 6 Setting the Remote Security Code The remote security code is initially preset to `000'. Depress the [ANSWER] key for about 2 seconds; the telephone will display `security code'. Use the [OGM] or [MEMO] button to set the appropriate digit. [. . . ] All erased messages will be recovered after a long "beep". Note: If there is no message in record, then there will be two short "beeps" to indicate that no message has been erased. Note: If any recording action is performed after all messages have been erased, the deleted messages cannot be recovered. Remote Control - After you hear the out going message, input the security code (Please refer to Setting the Remote Security Code). [. . . ]