User manual JWIN JX-CD488

[. . . ] Refer servicing to qualified service personnel. The exclamation point within an equilateral triangle is intended to alert the user to the presence of important operating and maintenance (servicing) instructions in the literature accompanying the appliance. CAUTION CLASS 1 LASER PRODUCT Use of Controls or adjustments or performance of procedures other than those specified herein may result in hazardous radiation exposure. LASER SAFETY This unit employs a laser. Only qualified service personnel should attempt repair. DANGER: INVISIBLE LASER RADIATION WHEN OPEN AND INTERLOCK FAILED OR DEFEATED. CAUTION: HAZARDOUS LASER RADIATION WHEN OPEN AND INTERLOCK DEFEATED. CLASS 1 LASER PRODUCT LUOKAN 1 LASERLAITE KLASS 1 LASERAPPARAT 1. [. . . ] AM/FM radio operation Switch the unit on by pressing the "POWER" button (1)/(32). Switch to the Tuner operating mode by pressing the button "TUNER / BAND" (7)/(53). About the tuner's preset station memories Each time the "MEM. /CLK ADJ. " button (9)/(50) is pressed, the memory positions are called up one after another in ascending number order. The memory positions are selected directly using the numerical keys "1 - 0 / +10" (33) on the remote control. Program sites 1 - 9; press the corresponding key "1- 9". Program sites 10 - 19; Press button "+10" and then the appropriate button " 0 - 9". Program site 20; Press button "+10" twice and then the button "0". Programming AM and FM Stations in Memory The program memory allows you store 30 stations in FM and AM range. Program place selection is described in the previous operating section. In TUNER mode, select to FM or AM reception. Seek out the station required by "Manual station selection" or "Station search operation". Press the "MEM. /CLK ADJ. " (9)/(50) and then Note: You can also directly select the desired program preset by pressing numeric buttons "1-0 / +10" (33) on the remote control. Press DISPLAY MODE, as required to check the current time, Timer On, and Timer Off. Press TIMER (22)/(54) to activate the timer. 3. 4. To switch to the clock display while in tuner and CD modes, press DISPLAY MODE. The time is displayed for approximately 10 seconds. The time is also displayed when the unit is turned off. Setting the timer You can set automatic switch-on and switch-off times with the built-in timer. Before you do this, be sure the clock is set correctly. With the unit on, press DISPLAY MODE (17)/ (48), as required, until TIMER ON appears in the display. Use the TUNING + SKIP/SEARCH or TUNING - SKIP/SEARCH to set the hour of the desired switch-on time. When the unit is on standby it will automatically switch on for the programmed length of time. The unit automatically selects the operating mode (CD or TUNER) it was in when last switched off. Make sure the tuner is tuned to a radio station, or for CD operation, a CD must be inserted. [. . . ] Press the " TUNING + or TUNING -" button (18) or (20) to select desired track. Press the "PLAY/PAUSE" button to play MP3. 3. Select the desired title using the numeric buttons "0 - 9 / +10" (33) on the remote control device or by repeatedly pressing " TUNING + or TUNING ". To play back the program, press the " PLAY / PAUSE" button (13)/(38). When " PLAY / PAUSE" is pressed, the program can be played back again as long as MEMORY appears on the display unit (3). [. . . ]