User manual KANGURU DATABANK

[. . . ] FCC COMPLIANCE STATEMENTS This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: Reorient or relocate the receiving antenna. [. . . ] Click "OK. " A dialog will appear with "NEC PCI to USB Enhanced Host Controller" highlighted, click "Next" to continue. Figure 4 · · · · · · · The "Windows driver file search for the device" dialog appears with the location of the driver. The "Window has finished installing the software that your new hardware device requires" dialog appears. Click "Finish. " Restart Windows. Figure 5 · · Finalizing USB 2. 0 Hi-Speed hardware settings USB 2. 0 Hi-Speed products that use an NEC chipset have 3 USB host controller engines on board. Two of the host controller engines handle USB 1. 1 transactions. One of the host controllers engines handle, USB 2. 0 transactions. USB data traffic is automatically routed to the proper host controller engine depending on the speed of the device that is plugged into the USB 2. 0 port. This essentially creates 3 concurrent USB buses. These USB buses allow devices to run in a less congested traffic environment. This helps devices such as color printers, scanners, video cameras and mass storage devices, which require a high bandwidth, to work well together. The NEC PCI to USB Enhanced Host Controller driver handles USB 2. 0 Hi-Speed (480 Mbits/s) traffic. The two NEC PCI to USB Open Host Controllers handle Full-Speed (12 Mb/s) and LowSpeed (1. 5 Mb/s) traffic. Check your Windows System/Device Manager to confirm proper installation of USB 2. 0 Hi-Speed drivers: NEC PCI to USB Enhanced Host Controller NEC PCI to USB Open Host Controller NEC PCI to USB Open Host Controller USB Root Hub USB Root Hub Connecting the Kanguru DataBank 1. ) Boot-up your computer and make sure the USB / USB2. 0 port device driver has been installed and is available in operating system. 2. ) Plug the USB2. 0 cable into the USB2. 0 Port of computer. 3. ) Plug the AC power cord to the inlet of your Kanguru DataBank and power on the DataBank. Your Kanguru DataBank will be ready to use. 4. ) Follow the Software Installation as seen below. NOTE: Labeling your Kanguru Disks One of features of the Kanguru DataBank is that the Kanguru Disks are hot swappable. This feature allows you to take any of the Kanguru Disks out while the DataBank is still operating, and replace it at a later time. When you want to remove a disk you have to disconnect it from the OS first. We highly recommend that users label their Kanguru Disk both internally and externally. By internally we are suggesting that you change the label of the drive. [. . . ] Step3 After restarting the system, a removable hard Drive is added to [My Computer ]. Choose the removable HDD and click right button of mouse. Select [Format] to format your Kanguru DataBank. You only can set the USB2. 0 Hard Disk Drive to one partition in this method. [. . . ]