User manual KANGURU INAS 100

[. . . ] BROADBAND NETWORK ATTACHED STORAGE Kanguru iNAS-100 User's Manual Copyright 2003, All Rights Reserved. This manual applies to 2. 12 or later versions of the Kanguru iNAS 100 CUSTOMER SERVICE 1 To obtain service or technical support for your system, please contact Kanguru Solutions Technical Support Department at 508-376-4245, or visit www. Kanguru. com for web support. TRADEMARKS Microsoft®, Windows® and Internet Explorer® are registered trademarks of Microsoft Inc. Novell® and NetWare® are registered trademarks of Novell Inc. [. . . ] You don't need to configure gateway address if the NAT function is enabled; just set it as 0. 0. 0. 0. Enable DHCP Server Once the DHCP server function is activated, the Kanguru iNAS 100 will assign dynamic IP addresses to any computer in the local network that is configured to automatically obtain IP addresses. Note: Only one DHCP server can be activated at any time in a network, or it may cause errors in communication. · Network File Services Microsoft Networking Users using the Kanguru iNAS 100 on the Microsoft Windows operating systems must start Microsoft Network Services. 28 If the local network has a WINS server installed, please specify the IP address. The Kanguru iNAS 100 will automatically register its name and IP address with the WINS service. Or you can enable your Kanguru iNAS 100 as the WINS server for your network. Apple Networking Users using the Kanguru iNAS 100 on Mac operating systems must enable AppleTalk network support. If your AppleTalk network uses extended networks and is assigned with multiple zones, please assign a zone name to the Kanguru iNAS 100. If you do not want to assign a network zone, please enter an asterisk (*). NFS Service Users using Kanguru iNAS 100 on a Unix/Linux operating system computer or server must start Unix/Linux NFS service. The Kanguru iNAS 100 supports NFS version 2. 0. To correctly use the NFS service, you must assign a User's UID and IP address. Please select User Management · Users · NFS Settings to start the setup. NetWare Service If you wish to use NetWare to access the Kanguru iNAS 100, you should activate the NetWare service. The Kanguru iNAS 100 will then operate in a manner similar to a Novell NetWare 3. 12 file server. Web Service Other than standard OS support, you have the choice to use a web browser to access your files on the Kanguru iNAS 100. If your Kanguru iNAS 100 is connected to the Internet and uses a valid IP address, the Kanguru iNAS 100 allows you to access your files using a web browser from anywhere in the world. FTP Service If you wish to download files from or upload files to your Kanguru iNAS 100 by using file transfer protocol (FTP), you must first activate the FTP service. · DNS Service DNS (Domain Name System) is used to map a domain name to its corresponding IP address and vice versa. A DNS server provides the domain name service through the network. Using this, you can create and manage your domain name in the Internet. If you do not know how to register a domain name, please contact your ISP. According to your domain configuration, you can configure the Kanguru iNAS 100 as the primary DNS server or as the secondary DNS server. [. . . ] When the ISP assigns a new WAN IP address, the Kanguru iNAS 100 will update the new address to the DynDNS server automatically. Registration Procedure Please follow below steps to register a dynamic domain name: Note: This guide is for reference only. If there are any changes, please refer to the instructions or documents on the web site. a. Open the browser and connect to http://www. dyndns. org. Click on "Sign Up Now" to begin the registration process. 55 56 b. [. . . ]