User manual KANGURU PRESENTER MOUSE

[. . . ] If this equipment does cause harmful interference to equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: Reorient or relocate the receiving antenna. Increase the Distance between the equipment and receiver. Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. [. . . ] And you can see the device is present using device manager (right click "My Computer" and click properties). 3. ) In Win98/Me operation system you need to follow the instructions on your screen. During the install process, the O/S may ask you to put Win98 CD into the CD-ROM 4. ) After the install process has finished, the remote should be working. If not, please read the "Setting the ID" section for further instructions. 4. Setting the ID Refer to this section of your the remote is not working or you are experiencing interference from another remote: 1. ) Push the M-key and Composite Switch Push key simultaneously at least 5 seconds (A Green LED light will flash) (Change a new ID). 2. ) Use a pen to push the receiver's button, but do not remove from the USB port to do so. You will feel the button click when it is pressed. 3. ) Push any button except the laser key or MKey to send a new ID to the receiver 4. ) You should now have full control of the mouse. Please note that every time you take the battery out, the mouse ID will be reset. If your mouse doesn't work then you have to do the steps 1 to 3 to set up a new ID again. You have 40 seconds when setting the receiver ID. 5. Using the Presenters Mouse The Kanguru Presenters mouse has two operating modes: mode1 for normal mouse functions as well as controlling the laser pointer and mode 2 for controlling the multimedia functions. Mode 1: · To use the laser pointer PUSH and HOLD the laser button and the clear button (M-KEY) for 5 seconds. The clear button will flash red when the laser has been activated. It will also blink every 2 seconds to let you know the laser is active. Follow the same instructions to turn the laser off. Mode2: · To launch your default Media Player (Windows Media Player, etc) push and release the clear button, then push the laser button. NOTE: The media functions were designed to work with Windows Media Player on a Windows ME operating system, so some options with other players may not work correctly. o If you push the clear button once, a green light will come on. This means you are in multimedia control mode. [. . . ] Do not stare into beam & keep out of the reach of children. Additional Notes Notes: For Mac use, the Mouse functions will work, but Multimedia controls WILL NOT. Range: Radio Frequency: Physical Dimensions: Weight: Battery Life: Roughly 25 yards. 125mm x 36mm x 19. 8 mm < 55 grams with Li Battery Expected for 10-12 months on 3V Lithium Battery Replace with a DC-3V CR2032 or a DC-3V CR2450 Battery Warranty This product carries a 1-year warranty from the date of purchase. Any claims for loss or damage must be made to carrier directly. [. . . ]