User manual KARCHER BR 40 10 C CLASSIC

[. . . ] : +49 7195 14-0 Fax: +49 7195 14-2212 Winnenden, 2012/12/01 DE -7 Stück 1 1 1 1 1 1 1 1 1 1 1 1 1 1 9 Please read and comply with these original instructions prior to the initial operation of your appliance and store them for later use or subsequent owners. Function The scrubber vacuum is used for wet cleaning or polishing of level floors. Two brush rollers located opposite of each other clean the floor by means of the added detergent liquid. A working width of 400 mm and a capacity of 10 l each of the fresh and dirt water reservoirs allow for effective cleaning. [. . . ] Do not operate the appliance on the spot. Polishing  Remove both vacuum bars from the appliance (see chapter "Maintenance tasks/replacing vacuum bar"). σ Turn on the brushes by using the switch for the brush drive. σ Swivel the slider toward the operator the chassis is retracted and the brushes touch the floor. σ Move the appliance over the surface to be processed by the slider. caution Risk of damage to the floor covering. Do not operate the appliance on the spot. Never operate a machine with damaged cables. The highest allowed net impedance at the electrical connection EN -3 12 Note To polish underneath furniture, the fresh water and wastewater reservoirs can be removed. σ Unscrew the star grips, remove the screws and take off the upper push handle half. storage Caution Risk of injury and damage!Note the weight of the appliance in case of storage. This appliance must only be stored in interior rooms. Shutting Down the Appliance  Release the switch for detergent solution. σ Push the appliance forward for another 1-2 m to draw off residual water. σ Press the pedal to lower the vacuum bar. σ Place the slider vertically - the brushes are elevated. When switching off the appliance, take the load off the appliance by placing the slider vertically. σ Press the push-button for the vacuum bar change toward the inside - the vacuum bar will release. σ Remove the screw springs and install the new vacuum bar. maintenance and care ƽ Danger Risk of electric shock , risk of injury!Pull the plug from the mains before carrying out any tasks on the appliance. [. . . ] Insufficient water quantity Check fresh water level, refill tank if necessary. Clean the ball valve in the fresh water reservoir. Check and ensure that the fresh water reservoir is seated properly on the appliance. Filter in the fresh water reservoir is plugged, clean filter. [. . . ]