User manual KARCHER HDS 798 CSX

[. . . ] In the area of this equipment, the regulations and requirements of the German republic does apply (can be subscribed by Carl Heymanns Verlag KG, Luxemburger Straße 449, 50939 Koeln): – accident or regulation "working with fluit high-pressure" BGR 500 Notice High-pressure jets must be inspected once a year, according to the UVV-guidelines BGR 500 by an expert. The Kärcher service engineers are exports and are permitted to conduct this stipulated inspection. The result of the inspection has to be documented. In the chapter " inspection documentation" the result of the inspectionmay be documented. [. . . ] Reset the thermostat of the hot air blower. shutdown In case of longer operational breaks:  Drain water. σ Rinse the plant with an anti-frost solution. Rinse the plant with an anti-frost solution Note Observe handling instructions of the antifreeze agent manufacturer. σ Fill anti-freeze agent of the trade into swimmer container. σ Switch on the plant (without heater) till the plant has been completely rinsed. a certain corrosion protection is achieved with this as well. Dump water  Screw off water supply hose and high pressure hose. σ HDS-C 7/11, HDS-C 9/15: Screw off supply hose at boiler bottom and drain heating spiral empty. 1 Warm water tank 2 Drain screw  HDS-C 8/15-E: Remove drain screw of the warm water tank and empty it. 1 minute until the pump and conduits are empty. Milky oil indicates that it contains water. Operator Operator Operator Clean the housing thoroughly from inside and outside. Operator Take care of the stainless steel casing using steel cleaner (order no. Clean detergent filter in the detergent container Remove filter and rinse it thoroughly with hot water. Operator Operator Operator Operator Customer Service Customer Service Customer Service Clean sieve in the water short- See Maintenance tasks age safe guard. Lubricate the door hinges Door locks Lubricate the hinges with grease (order no. After 250 operating hours or once every six months After 500 operating hours or once a year Check pump head Only HDS-C 7/11, HDS-C 9/ 15: Adjust ignition electrodes, replace if required Check the high pressure pump thoroughly Oil change in high pressure pump Only HDS-C 7/11, HDS-C 9/ 15: Desoot the heating coil, adjust burner Only HDS-C 7/11, HDS-C 9/ 15: Decalcify the heating coil Only HDS-C 7/11, HDS-C 9/ 15: Clean the fuel container See Maintenance tasks See Maintenance tasks See Maintenance tasks Operator Customer Service Trained operator Operator 24 EN -8 Maintenance Works Oil change ƽ Danger Risk of burns due to hot oil or hot parts of the plant. Allow pump to cool down for 15 minutes before oil change. Note Please dispose off used oil only in the collection points provided for them. Please hand over old oil, if any, only at such places. Polluting the environment with used oil is a punishable offence. [. . . ] σ Insert the inlet hose from the bottom through the plant opening and connect it. σ Determining the hardness of tap water: – through the public water supply works, – Using hardness testing set, order no. 1 Speed potentiometer 28 EN - 12 Fill in hardening liquid EC Declaration of Conformity We hereby declare that the machine described below complies with the relevant basic safety and health requirements of the EU Directives, both in its basic design and construction as well as in the version put into circulation by us. This declaration shall cease to be valid if the machine is modified without our prior approval. [. . . ]