User manual KARCHER RC4000

[. . . ] EN Unpacking the Appliance EN Installing the access ramp of the station . EN Parking the cleaning robot EN Terminate operation / switch off . 1 1 2 2 2 3 3 4 4 4 Dear Customer, Please read and comply with these original instructions prior to the initial operation of your appliance and store them for later use or subsequent owners. english Proper use The RoboCleaner consists of two units: a station and a battery-operated cleaning robot. [. . . ] σ Then press the brush roller into the right hand side holder with the hook facing down; ensure that it locks into place. Clean dust sensors  Empty the dirt receptacle and open it (refer to the description above). Illustration  Clean the dust sensors using a soft cloth or a soft paintbrush. Cleaning robot Cleaning the wheels  Clean the running surfaces of the wheels when these become dirty. ) can collect on the running surface and damage sensitive, smooth floor surfaces. Begin all maintenance work on the cleaning robot with the following steps:  Empty the dirt receptacle; see Chapter "Start-up“. σ Opening the dirt receptacle: Rotate the cleaning robot and place it on a soft surface. Illustration Open both locking levers of the dirt receptacle. Illustration Remove the cover of the dirt receptacle. Cleaning the flat filter Clean the flat filter in the cleaning robot every time you exchange the filter bag in the station. σ Empty the dirt receptacle and open it (refer to the description above). Illustration  Remove the flat filter from the dirt receptacle. σ Shake out the flat filter, or clean it using a small soft brush. 26 EN – 8 Finish all maintenance work on the cleaning robot with the following steps:  Installing the dirt receptacle cover: Illustration Put the cover onto the dirt receptacle. illustration 27 Close both locking levers. In addition, press on the front side of the cover to ensure the dirt receptacle is closed safely. Exchanging the batteries Illustration 28  Release the two screws on the two batteries, and remove the old batteries. σ Insert the new batteries, and fasten them with the screws. 0 Disposing of old device and battery pack The cleaning robot includes two built-in battery packs; please remove these before disposing of the old appliance. σ Please arrange for the proper disposal of the old appliance. Remove battery pack and dispose of  Remove both battery packs of the cleaning robot; see Chapter "Replace batteries“. σ Dispose of the batteries properly (at a collection site or the dealer). [. . . ] You have to remove the filter from the robot and clean it (see Chapter "Cleaning flat filter“). What happens if the robot gets stuck while I am not at home?The robot stops at this point and displays the signal for being stuck. If no more light is blinking, the batteries are depleted and must be recharged. [. . . ]