User manual KARCHER RDS1 SB-C SB-M

[. . . ] Can be entered with the modem software HSComm. Total sales washing area 1 Total sales washing area 8 Note Only the sales of the washing systems available in the plant are displayed. Can be entered with the modem software HSComm. Daily sales washing area 1 Safety instructions General To avoid danger to persons, animals and property before the first operation of the system, read: – this operating instructions manual – the operating instructions manual of the car washing unit associated with the controls – all safety instructions – the respective national statutes of the legislator For the operation of this system the following regulations and directives are applicable in the Federal Republic of Germany (available from Carl Heymanns Verlag KG, Luxemburger Straße 449, 50939 Cologne): – Accident prevention provision "General rules and regulations" BGV A1 – Order in respect of operational safety (BetrSichV). [. . . ] σ Start the configuration software "HSCom" on the PC. The programme automatially establishes the link to the GSM modem. Note If the message "Monitoring time expired" is displayed, it means the connection cannot be established automatically. In such a case, click the "Synchronise RS232" button followed by the "Read settings" button in the screen. This process can take approximately 1 minute. Repeat the process if error messages are displayed. σ Click "Alarm/Switch1" tab; you can now modify the settings given below it. Changing the settings You need a PC to modify the settings. The enclosed configuration software from INSYS should be installed on the PC. Changing the mobile services provider Note Before changing, check whether the desired mobile network is available where the plant/system is installed. Keep the SIM card and the corresponding PIN number ready. Only SIM cards with 3V power supply may be used. The voltage details are printed on the SIM card. For prepaid cards, ensure that you have enough balance on the card. σ Press release button of the SIM card holder. σ Remove the SIM card from the card holder. σ Disconnect serial cable between GSM modem and control at the controls and connect it to the PC. σ Switch on RDS1 switch - the GSM modem will be initialised: The "Connect" LED glows for approx. Note If the message "Monitoring time expired" is displayed, it means the connection cannot be established automatically. In such a case, click the "Synchronise RS232" button followed by the "Read settings" button in the screen. This process can take approximately 1 minute. Repeat the process if error messages are displayed. [. . . ] 1 2 3 – List of telephone numbers Fault/error messages "Other Receivers" tab. You can enter a maximum of 20 different additional receivers in the list of telephone numbers. Each message can be sent to a maximum of 10 receivers. The respective message is sent to the receivers who are checked in the column for the message with a tick mark. [. . . ]