User manual KARCHER SC 1402

[. . . ] The unit may be operated only by persons who have been thoroughly instructed in its use, or who have provided proof of their ability to operate the unit, and who have been expressly charged with operating the unit. The appliance is not intended for use by young children or infirm persons without supervision. Young children should be supervised to ensure that they do not play with the appliance. The unit must never be without supervision while it is operating. [. . . ] That allow direct steam contact Never fill the tank with solvent-bearing with electrical wiring and switches. This particularly steam could enter into the electrical includes cleaning agents, petrol or paint components and, on condensing, cause an thinner. Use acetone, undiluted acids and solvents, because they attack the materials of which the unit is constructed. Make sure that the water reservoir (B1) is everything is complete (see page 3). Any missing parts or you detect any transport Do not operate the decalcification pump damage, please inform your dealer immediately. Otherwise, you pump water into the appliance which spurts out of the steam Disposal of the packaging. Please do not place the packaging into · plug the mains plug (A7) into a mains plug. The ordinary refuse for disposal, but The steam cleaner is ready for use after arrange for the proper recycling. Push the lock for the steam lever (A4) forwards (steam lever is released). Connect, if necessary, the detail nozzle (C1) or Do not operate the steam lever when the the round brush (C2) with the steam nozzle (A2). Line up both grooves of the accessories with · Turn the accessory clockwise until it locks into The amount of steam flowing out increases place. Apply a then use this cloth to wipe over the furniture. Small quantity of steam to the entire glass surface. This is of distance of approximately 20 cm until the importance because glass surfaces that are surface is moistened evenly. Strip the glass surface in straight lines from the top to the bottom using the rubber lip of the Steam nozzle (A2) window tool. You can use the steam jet directly from the steam · Wipe the rubber lip and the bottom edge of the window dry after each strip. nozzle without any further accessories. The closer you hold the nozzle to the dirty spot, Removing dust from plants: the higher the cleaning effect, as the temperature Respect a distance of 20-40 cm. And pressure of the steam reach their maximum values immediately when they are emitted from the nozzle. Prior to performing any maintenance work, Start of the decalcification and before replacing parts, the power plug · The steam cleaner must be disconnected from the electrical mains and must be cooled. When using Faults often have simple causes which you can the descaling solution, mind the dosing rectify yourself with the aid of the following suminstructions on the packaging. In case of doubt or of faults or remedies Use caution when filling and emptying the not mentioned here apply to the authorized custeam cleaner. [. . . ] We will repair potential failures of the appliance within the warranty period free of charge, provided that such failure is caused by faulty material or defects in fabrication. Only use accessories and spare parts which have been approved by the manufacturer. The exclusive use of original accessories and original spare parts ensures that the appliance can be operated safely and troublefree. Please see the last page for an illustration of the appliance with the order numbers of the individual components. [. . . ]