User manual KARCHER SCP 12000 IP LEVEL SENSOR

[. . . ] Please do not place the packaging into the ordinary refuse for disposal, but arrange for the proper recycling. Old appliances contain valuable materials that can be recycled. Please arrange for the proper recycling of old appliances. Please dispose your old appliances using appropriate collection systems. [. . . ] Illustration  Place the flat seal into the hose connection piece. If you would like to prevent the water that is standing in the hose or above the pump after the pump has been turned off, we recommend that you use the included backflow valve. Before inserting the backflow valve, the flat seal must be removed. illustration  For a 11/4“ (31. Illustration  Unfold the folding legs if you are working without pre-filter (only SCP 12000 ). You can buy the pre-filter as an accessory. Illustration  Set the IQ Level Sensor to the desired switching height. The IQ Level Sensor can be removed from the guide rail toward the top and placed separately if necessary. Illustration  Place the pump on a level, stabile surface in the liquid to be transported, ensure that it is standing firmly or immerse it using a rope tied to the handle. The suction area should not be blocked fully or partially through the impurities. Illustration  When installing the pump, you must make sure that the pump can be submerged up to the max. The flow height indicates the height difference between the water level and water exit at the end of the flow hose. You have to adhere to the flow height for the pump to flow. This must be observed throughout the entire pump run, as the flow height will increase with a decreasing water level (due to the pumping). EN – 3 15 Operation The fluid level must be minimum 3 cm (SCP 1200) or 8 cm (SDP 14000) for the pump to suck in automaticallt. If the liquid level is less than 4 cm (only SCP 12000), proceed according to instructions in the chapter of flat suction. The IQ Level Sensor controls the pumping operations. The pump starts when the fluid level reaches the IQ Level Sensor. The pump switches off automatically after 10 to 60 seconds (depending on the ambient conditions) when the fluid level falls below the IQ Level Sensor. The pump automatically conducts the adaptation to the necessary trail time/ pump time. Of 24 hours or until the mains plug is pulled out. If the mains plug is pulled prior to the 24 hour time period, or after the 24 hours have elapsed, the pump will automatically set the trail time/pump time to the set value of 10 seconds. [. . . ] Air in the pump Press the ventilation button or plug in/ disconnect the mains plug of the pump a few times till the fluid gets sucked. Pull out the mains plug and clean the suction area Immerse, whenever possible, the pump deeper into the liquid or, in case of SCP 12000, proceed according to instructions in the chapter on flat suction. Clean the IQ Level Sensor with clear water and a cloth. Pump runs but does not transport Suction area blocked Water level below minimum water level Max. [. . . ]