User manual KAWAI ACR-20

[. . . ] 5-17 Checking the drives for data consistency . 5-22 Selecting the boot drive from a RAID set . 5-32 Setting the Boot array in the BIOS Setup Utility. 1 vii Notices Federal Communications Commission Statement This device complies with Part 15 of the FCC Rules. [. . . ] Main BMC Firmware: O/S Watchdog Timer O/S Wtd Timer Timeout O/S Wtd Timer Policy System Event Log BMC network configuration O/S Watchdog Timer [Disabled] If enabled, starts a BIOS timer which can only be shut off by Intel Management Software after the OS loads. Helps determine that the OS sucessfully loaded or follows the O/S Boot Watchdog TImer Policy. Configuration options: [Enabled] [Disabled] O/S Wtd Timer Timeout [10 minutes] Allows you to configure the length of the O/S Boot Watchdog Timer. not available if O/S Boot Watchdog Timer is disabled. Configuration options: [5 minutes] [10 minutes] [15 minutes] [20 minutes] O/S Wtd Timer Policy [Reset] Allows you to configure how the system should respond if the OS Boot Watchdog Timer expires. Server Mgmt Change this to enable or disable all features of system Event Logging during boot. Enabling/Disabling Options SEL Components Erasing Settings Erase SEL When SEL is Full [Disabled] [No] [Do Nothing] Note: All values changed here do not take effect until computer is restarted. SEL Components [Disabled] Allows you to enable or disable all features of system Event Logging during boot. The following items appears only when you set SEL Components to [Enabled]. All values changed here do not take effect until computer is restarted. Erase SEL [No] Allows you to choose options for erasing SEL. The Boot menu items allow you to change the system boot options. Setup Prompt Timeout [xx] Use the <+> and <-> keys to adjust the number of seconds to wait for setup activation key. Bootup NumLock State [On] Allows you to select the power-on state for the NumLock. Configuration options: [Off] [On] Full Screen Logo [Enabled] Allows you to enable or disable the full screen logo display feature. Configuration options: [Disabled] [Enabled] Set this item to [Enabled] to use the KAWAI MyLogo2TM feature. CSM16 Module Version GateA20 Active [Upon Request] [Upon Request] GA20 can be disabled using BIOS services. This option is useful when any RT code is executed above 1MB. Option ROM Messages [Force BIOS] Allows you to set the display mode for Options ROM. configuration options: [Force BIOS] [Keep Current] 4-42 Chapter 4: BIOS setup Interrupt 19 Capture [Enabled] Allows Option ROMs to trap interrupt 19. Configuration options: [Disabled] [Enabled] Boot Device Seeking [Endless PXE] [Endless PXE] Continuously searches for the remote boot image until it is found or the process is aborted (press Ctrl+Alt+Del). [Normal] Searches for the remote boot image once, then stops. [. . . ] 6-28 Chapter 6: Driver installation 6. 7 Intel® WG82574L Gigabit Adapters Driver installation This section provides the instructions on how to install Intel® WG82574L Gigabit Adapters Driver. Insert the motherboard/system support DVD to the optical drive. The DVD automatically displays the Drivers menu if Autorun is enabled in your computer. [. . . ]