User manual KAWAI CA71

[. . . ] The GPL and LGPL licensed code in this product is distributed without any warranty. Copies of these licenses are included in this product. You may obtain the complete corresponding source code (as defined in the GPL) for the GPL Software, and/or the complete corresponding source code of the LGPL Software (with the complete machinereadable "work that uses the Library") for a period of three years after our last shipment of the product including the GPL Software and/or LGPL Software, which will be no earlier than December 1, 2011, either (1) for free by downloading it from http://support. Com/download; or (2) for the cost of reproduction and shipment, which is dependent on the preferred carrier and the location where you want to have it shipped to, by sending a request to: KAWAITeK Computer Inc. [. . . ] CPU C1E [Auto] [Enabled] [Disabled] Enables the C1E support function. This function must be enabled to enable or disable the Intel® Turbo Mode Technology. CPU C3 Report [Auto] CPU C6 Report [Auto] Allows you to disable or enable the CPU C3 report to OS. Allows you to disable or enable the CPU C6 report to OS. KAWAI CA71 3-17 Chapter 3 Allows you to enable or disable the Enhanced Intel® SpeedStep Technology (EIST). [Disabled] The CPU runs at its default speed. High Precision Timer [Enabled] Allows you to enable or disable the High Precision Event Timer. 3 SATA Configuration While entering Setup, the BIOS automatically detects the presence of SATA devices. The SATA Port items show Not Present if no SATA device is installed to the corresponding SATA port. SATA Mode Selection [AHCI Mode] Allows you to set the SATA configuration. [IDE] [AHCI] Set to [IDE] when you want to use the Serial ATA hard disk drives as Parallel ATA physical storage devices. The USB devices can be used only for the BIOS setup program. Allows the system to detect the presence of USB devices at startup. if detected , the USB controller legacy mode is enabled. If no USB device is detected, the legacy USB support is disabled. Enables the support for operating systems without an EHCI hand-off feature. 6 Onboard Devices Configuration Scroll down to display the following items: HD Audio Controller [Enabled] [Enabled] [Disabled] Enables the High Definition Audio Controller. The following two items appear only when you set the Azalia HD Audio item to [Enabled]. Front Panel Type [HD] [HD] [AC97] Allows you to set the front panel audio connector (AAFP) mode to legacy AC'97 or highdefinition audio depending on the audio standard that the front panel audio module supports. sets the front panel audio connector (AAFP) mode to high definition audio. Sets the front panel audio connector (AAFP) mode to legacy AC'97 KAWAI CA71 3-23 Chapter 3 SPDIF Out Type [SPDIF] [SPDIF] [HDMI] Sets to [SPDIF] for SPDIF audio output. (USB3_34, SATA6G_E1/E2, PCIeX1_1, PCIeX1_2 are disabled for system resource optimization. [. . . ] If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: · Increase the separation between the equipment and receiver. Connect the equipment to an outlet on a circuit different from that to which the receiver is connected. Consult the dealer or an experienced radio/TV technician for help. The use of shielded cables for connection of the monitor to the graphics card is required to assure compliance with FCC regulations. [. . . ]