User manual KAWAI CP110

[. . . ] The GPL and LGPL licensed code in this product is distributed without any warranty. Copies of these licenses are included in this product. You may obtain the complete corresponding source code (as defined in the GPL) for the GPL Software, and/or the complete corresponding source code of the LGPL Software (with the complete machinereadable "work that uses the Library") for a period of three years after our last shipment of the product including the GPL Software and/or LGPL Software, which will be no earlier than December 1, 2011, either (1) for free by downloading it from http://support. Com/download; or (2) for the cost of reproduction and shipment, which is dependent on the preferred carrier and the location where you want to have it shipped to, by sending a request to: KAWAITeK Computer Inc. [. . . ] (SATA6G_E1/E2, PCIeX1_1, PCIeX1_2 are disabled for system resource optimization. ) PCIeX16_3 slot runs at X1 mode for more available PCIeX1 slots. Allows you to select the ASM1061 storage controller operating mode. Chapter 3 3-24 ASM1061 Storage OPROM [Enabled] This item appears only when you set the previous item to [Enabled] and allows you to enable or disable the OptionRom of the ASM1061storage controller. Intel LAN Controller [Enabled] Chapter 3: BIOS setup Intel PXE OPROM [Disabled] This item appears only when you set the previous item to [Enabled] and allows you to enable or disable the PXE OptionRom of the Intel LAN controller. Configuration options: [Enabled] [Disabled] Serial Port Configuration The sub-item in this menu allow you to set the serial port configuration. This item functions only if there is a serial port (COM1) connector on the motherboard. Serial Port [Enabled] Allows you to enable or disable the serial port (COM). Configuration options: [Enabled][Disabled] Change Settings [IO=3F8h; IRQ=4] Allows you to select the Serial Port base address. 7 APM EFI BIOS Utility - Advanced Mode Exit Main Back ErP Ready Restore AC Power Loss Power On By PCI Power On By PCIE Power On By Ring Power On By RTC Ai Tweaker Advanced\ APM > Advanced Monitor Boot Tool Disabled Power Off Disabled Disabled Disabled Disabled Allow BIOS yo switch off some power at S5 to get the system ready for ErP requirement. When set to Enabled, all other PME options will be switched off. [Silent] Sets to [Silent] to minimize the fan speed for quiet CPU fan operation. The following four items appear only when you set CPU Fan Profile to [Manual]. CPU Upper Temperature [70] Use the <+> and <-> keys to adjust the upper limit of the CPU temperature. The values range from 40ºC to 90ºC. Duty Cycle(%) [100] Use the <+> and <-> keys to adjust the maximum CPU fan duty cycle. When the CPU temperature reaches the upper limit, the CPU fan will operate at the maximum duty cycle. CPU Lower Temperature [20] Displays the lower limit of the CPU temperature. aSUS CP110 3-29 Chapter 3 CPU Fan Min. Duty Cycle(%) [20] Use the <+> and <-> keys to adjust the minimum CPU fan duty cycle. When the CPU temperature is under 40ºC, the CPU fan will operate at the minimum duty cycle. Chassis Fan Speed Low Limit 1/3 [600 RPM] This item appears only when you enable the Chassis Q-Fan Control feature and allows you to disable or set the chassis fan warning speed. [. . . ] If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: · Increase the separation between the equipment and receiver. Connect the equipment to an outlet on a circuit different from that to which the receiver is connected. Consult the dealer or an experienced radio/TV technician for help. The use of shielded cables for connection of the monitor to the graphics card is required to assure compliance with FCC regulations. [. . . ]