User manual KAWAI CP200

[. . . ] KAWAI assumes no responsibility or liability for any errors or inaccuracies that may appear in this manual, including the products and software described in it. Product warranty or service will not be extended if: (1) the product is repaired, modified or altered, unless such repair, modification of alteration is authorized in writing by KAWAI; or (2) the serial number of the product is defaced or missing. Products and corporate names appearing in this manual may or may not be registered trademarks or copyrights of their respective companies, and are used only for identification or explanation and to the owners' benefit, without intent to infringe. 1 Installing the ASMB6 management board . [. . . ] Setup Prompt Timeout [xx] Use the <+> and <-> keys to adjust the number of seconds to wait for setup activation key. Bootup NumLock State [On] Configuration options: [Off] [On] This item allows you to select the power-on state for the NumLock. Full Screen Logo [Enabled] This item allows you to enable or disable the full screen logo display feature. Set Full Screen Logo to [Disabled] to select the desired Post Report waiting time from 1~10 sec. Post Report [5 sec] Allows you to select a desired post report waiting time. This item only appears when you set the Full Screen Logo to [Disabled]. Configuration options: [1 sec] - [10 sec] [Until Press ESC KAWAI CP200 4-47 CSM16 Module Version GateA20 Active [Upon Request] [Upon Request] [Always] GA20 can be disabled using BIOS services. Do not allow disable GA20; this optionis useful when any RT code is executed above 1MB. Option ROM Messages [Force BIOS] Allows you to set the display mode for Options ROM. configuration options: [Force BIOS] [Keep Current] Interrupt 19 Capture [Enabled] Allows Option ROMs to trap interrupt 19. Configuration options: [Disabled] [Enabled] Boot Device Seeking [Endless PXE] [Endless PXE] [Normal] Continuous seek remote boot image until boot image found or user abort (press Ctrl+Alt+Del). In Setup the User will have Administrator rights The password length must br in the following range: Minimum length 3 Maximum length 20 Administrator Password User Password Set Setup Administrator Password · If you have forgotten your BIOS password, erase the CMOS Real Time Clock (RTC) RAM to clear the BIOS password. 6 Jumpers for information on how to erase the RTC RAM. The Administrator or User Password items on top of the screen show the default Not Installed. After you set a password, these items show Installed. ⷠAdministrator Password If you have set an administrator password, we recommend that you enter the administrator password for accessing the system. Otherwise, you might be able to see or change only selected fields in the BIOS setup program. From the Create New Password box, key in a password, then press <Enter>. From the Enter Current Password box, key in the current password, then press <Enter>. From the Create New Password box, key in a new password, then press <Enter>. To clear the administrator password, follow the same steps as in changing an administrator password, but press <Enter> when prompted to create/confirm the password. After you clear the password, the Administrator Password item on top of the screen shows Not Installed. [. . . ] If you are using a Triple SLI system, ensure to install the NVIDIA® 3-way SLI driver under Windows® VistaTM. 6 Enabling the NVIDIA® SLITM technology After installing your graphics cards and the device drivers, enable the SLI feature in NVIDIA® Control Panel under the Windows® 7TM operating system. You can launch the NVIDIA Control Panel by the following two methods. Right click on the empty space of the Windows® desktop and select NVIDIA Control Panel. [. . . ]