User manual KAWAI FS640

[. . . ] The instructions apply to several models. Text relating only to specific appliances is marked with an asterisk (*). Instructions for action are marked with a action are marked with a . 1 Description of appliance and equipment Note u Place food inside the appliance as shown in the diagram. [. . . ] It must be outside the area of the rear of the appliance. 9 In the case of appliances without enclosed wall spacers, or if the enclosed spacers are not used, the dimension is reduced by 35 mm (see 4. The appliance can be inserted into a row of kitchen units. 9 (2) to the height of the row of units, a suitable stack cabinet Fig. 9 (1) can be fitted above the appliance. When building in with kitchen units (max. if the alarm status persists: (see Malfunction). Note Food may be spoilt if the temperature is not cold enough. 3 (3) the number of times needed until the required temperature shines in the LED display. Note u Long pressing of the setting button sets a slightly colder value within a small temperature range (e. The LED of the next lower temperature range then shines in the temperature display. W The food does not freeze onto the rear wall. The broken fragments may cause laceration. 2 Setting the temperature The temperature depends on the following factors: - the door opening frequency - the room temperature at the site where the appliance is installed - the type, temperature and quantity of frozen food Temperature setting to be recommended: 5 °C The temperature can be changed continuously. Once the 1 °C setting is reached, it starts again with 9 °C. W The LED of the current temperature flashes in the temperature display. U The glass shelf with stop face (2) has to be at the back. 6 Removing the storage rack u Remove storage rack according to illustration. 3 Thawing food u in the refrigerator compartment at room temperature in a microwave oven in a conventional or fan oven Remove only as much food as is required. U Food once thawed should be re-frozen only in exceptional cases. 7 Removing the bottle holder u Remove the bottle holder according to the illustration. 4 Setting the temperature Temperature setting to be recommended: -18 °C The temperature can be changed continuously. [. . . ] If this is not the case, please contact the customer service whose address is given in the enclosed customer service list. This noise comes from the refrigerant flowing in the refrigeru The sound is normal. The noise is produced whenever the refrigeration unit (motor) automatically switches on or off. It is briefly a little louder when the refrigeration unit (the motor) switches on. [. . . ]