User manual KAWAI FS900

[. . . ] In this case, repair may not be possible. Before use, perform preliminary check as described in this manual. Introduction Unauthorized copying of this manual in part or in full, except for private use, is prohibited. Unauthorized reproduction is strictly prohibited. shall not be responsible in any way for lost profits or any claims by third parties in case of any damage occurring from unsuitable use of this product. [. . . ] Even a single hair or a single grain of sand may cause water leakage. <Examples of foreign matter sticking to the waterproof packing> Hair Fibers Grains of sand 2. The speed at which the waterproof packing deteriorates depends on usage and storage conditions. If the waterproof packing is damaged, shows cracks, or has lost its elasticity, leakage may result. This product has an airtight plastic (polycarbonate) construction. Its water resistant properties may be affected if it is deformed by exposure to high temperatures for a long period (for example, if it is left in an automobile, on a boat, or at the beach), or subjection to uneven external force for a long time. Also, do not place heavy objects on this product during storage or transport. When the surface in contact with the waterproof packing is pressed strongly from the outside of the product, or when the product is twisted, the water resistant function may be lost. Before using this product, perform the preliminary test and the final check. If you notice drops of water or other signs of water leakage while taking pictures, stop shooting immediately, remove any water from the camera and the product, and perform the tests in "Final check" to determine whether leakage has occurred or not. E-5 Handling the Product Do not use or store the unit in places such as listed below: Doing so may cause malfunctions, defects, damage, fire, internal clouding, or water leakage. Areas exposed to direct sunlight and high temperatures (e. g. The controls on the case operate the corresponding functions on the digital camera. For more details about these functions, refer to the digital camera's instruction manual. E-9 Master the basics. Before taking any pictures, make sure you have mastered the basics of using the case. How to press the shutter button Press the shutter button gently, so that there is no movement of the camera. Also take care not to cover the lens with your hand. Note: · For detailed instructions on shutter operation, refer to the digital camera's instruction manual. How to Use the zoom button The case is equipped with a zoom button that allows you to operate the zoom button of the installed digital camera. How to use the mode dial The case is equipped with a mode dial knob hat allows you to operate the mode dial of the installed digital camera. After installing the digital camera in the case, seal the case and confirm that the mode dial can be operated. E-10 2. Preliminary Check of the Case Check the product before use. Before using the case underwater, be sure to confirm that the case is leak-free by performing the preliminary test before installing the camera. After installing the camera, perform the water leakage test again. Preliminary test 1. Confirm that the case's waterproof packing is free of sand, dirt or other foreign matter. If any foreign matter is attached, remove it completely. Before installing the digital camera in the case, immerse the empty case at the water depth at which you intend to use it to confirm that there is no water leakage. Main causes of water leakage are as follows. Waterproof packing damage, cracks, deterioration or deformation. [. . . ] Is there any abnormality with the waterproof packing where the case opens?Are the waterproof packing and the waterproof packing contact surface free of dirt and other foreign matter? E-13 Seal the case. Close the rear lid of the case, engage the buckles with the edge of the rear lid, and tilt the left grip in the direction of the arrow to seal the case airtight. Perform the final checks. Always check your pictures on the LCD monitor after shooting. E-16 5. Handling After Shooting Wipe off any water drops. Once you're back on dry land, wipe any water off the case. [. . . ]