User manual KAWAI K11

[. . . ] These pictographs and their meanings are shown below. WARNING CAUTION Please pay particular attention to this information. If ignored when using the product, there is a risk of serious injury and even death. Ignoring this information when using the product could lead to injury or material damage. [. . . ] Resistance increases as the PER-E02 extension ring is screwed in more deeply. However, be sure to screw it in all the way until there is no gap visible between the case's port mount thread and the extension ring's threaded section. If the resistance is extremely high, apply some more silicone O-ring grease again to surfaces listed above. Align the lens port mount thread of the PER-E02 extension ring with the threaded section on the K11. However, be sure to screw it in all the way until there is no gap visible between the K11's thread section and the extension ring's port mount thread. If the resistance is extremely high, apply some more silicone O-ring grease again to surfaces listed above. E-3 3 Attaching/Removing the Front Cap To attach the front cap, fit it into the front end (lens hood) of the K11 as shown below. The front cap can be removed by reversing the attaching procedure. Be sure to remove the front cap before shooting. CAUTION: 4 Adjusting the Lens Hood Position If the corners of the image in the pickup finder are cut off after the K11 is attached, adjust the lens hood position. Using the clamping screw securing wrench provided with the K11, loosen the four lens hood clamping screws on the K11. CAUTION: When the K11 and PER-E02 extension ring are removed from the PT-E series case, water drops on the O-rings may splash on the lens or camera. If this happens, wipe the water drops away from the lens and camera with a dry cloth. Make sure that all of the parts are completely dry before dismounting. Turn the lens's zoom ring so that the "10mm" mark is aligned with the zoom index. Fit the zoom gear by aligning the mark with the index. Zoom gear Confirm that the position alignment mark on the zoom gear is aligned correctly with the index on the lens and that the zoom gear is attached properly. Two marks are provided on the zoom gear. Two position alignment marks are provided on the gear periphery. CAUTION: If the zoom gear position is not aligned correctly, smooth zooming control is not possible. Be sure to attach the zoom gear to the correct position. 2) When using the ZUIKO DIGITAL ED 8mm Fisheye lens To enable manual focusing of this lens, we are developing a separately available MF gear (to be released in early 2006) for attachment to the lens's MF ring. [. . . ] Also remove any foreign matter from the O-ring contact surfaces and from the port mount thread on the PT-E series case. After removing foreign matter, apply the provided grease to the O-rings and fit them into the O-ring grooves. To apply grease to each O-ring, squeeze a drop of grease about the size of a grain onto your finger and lightly rub the entire circumference of the O-ring to spread the grease thinly and evenly. 935 g Applicable case Applicable lens Main materials Main body Lens O-rings Front cap Rear cap Withstanding pressure Dimensions Weight Note) We reserve the right to change the external appearance and specifications without notice. [. . . ]