User manual KAWAI X65-D

[. . . ] Page 5 Rotor Drive A Caterpillar® wet clutch with automatic belt tension adjustment delivers efficient and reliable power to the pavement. The rotor drive consists of field-proven Cat® D8 Track-type Tractor components for Caterpillar machine commonality and long service life. Page 5 2 Rotor Options With a choice of three rotor options, the X65-D can be configured for different applications and production requirements. page 6 Operator's Station Ergonomic design emphasizes comfort , visibility and easy operation. [. . . ] All gauges and displays are easily visible in direct sunlight or low light conditions. Isolated platform with four heavy-duty rubber mounts to reduce machine vibration transmitted to the operator. Low sound levels help the operator and ground crew communicate effectively. Warning horns and shut down buttons located on the operator's station and at five ground level control stations. Electronic Control Module (ECM) receives input signals from sensors in the engine, propel, steering and rotor drive systems which monitor current operating conditions. Self-diagnostics provides information for troubleshooting and alerts the operator of potential system problems. Automatic load control adjusts propel speed so that engine speed is maintained at no less than 1900 rpm. Machine always works at peak efficiency for maximum production. Steering control provides four steering modes for maneuvering in tight quarters: front steer only, crab steer, coordinated steer and rear steer only. 8 Automatic Grade and Slope Control The optional contacting or non-contacting grade controls provide precise control of the machine to a preset cutting depth. System can be configured to control grade or cross slope. Positive traction control valve provides equal hydraulic oil flow to each drive motor to increase tractive effort in hard or deep cuts. Operator can activate by a switch on the operator's console. Drive motors have two swashplate positions allowing operation at either maximum torque for work or greater speed for moving around the job site. gear selection controlled electrically by a two-position switch on the operator's console. Infinitely variable machine speed and direction of travel controlled by propel lever. Load sensing system, controlled by Electronic Control Module (ECM), matches propel speed to load on the engine. 5") long, 348 mm (14") wide and feature replaceable, steel reinforced polyurethane track pads for long life. The rotor clutch system has a separate oil sump, pump, filter, clutch control valve and oil cooler to provide continuous cooling and lubrication. Upper and lower sheave bearings are continuously lubricated with oil from the clutch sump to provide long life. One eleven-rib high tensile strength drive belt drives the rotor through a drum drive gear reducer located inside the rotor mandrel. the Caterpillar D8 Track-type-Tractor drum drive gear reducer provides reliability and long service life. [. . . ] Hydraulic oil cooler located at the rear of the machine and arranged in a modular stacked design for efficient cooling and easy access for cleaning. Three-micron filtration on pressure side of auxiliary flow, seven-micron filtration on return side. Track assembly features track frame stops to limit track angles to provide machine's ability to propel up inclines and out of deep cuts. top of deck and steps features non-skid treads for sure footing. [. . . ]