User manual KAZ 3000

[. . . ] Do not use humidifier if room air is excessively humid (greater than 50% relative humidity). excessive humidity is indicated by condensation on cold surfaces or walls in the room. For proper humidity readings, use a hygrometer available in most hardware and department stores. Moisture output will be higher when room air is dry, and lower when humidity is higher. [. . . ] Model 3400: Be sure that switch is in the middle Off (O) position. Model 3400: Turn the switch to either of the two speeds Low (I) or High (II). CAUTION: Turn off the humidifier if moisture condenses on cold surfaces and walls. condensation indicates excessive humidity and may result in water damage. To get the most benefit from the humidifier and to avoid product misuse, follow all instructions carefully, specifically the operation, care and maintenance guidelines. Please note that this is an electric appliance and requires careful attention when in use. Tap water may contain pollutants and minerals (scale) that can deposit on the inner surfaces of the humidifier and clog the Wicking Filter. Such scale can accelerate the growth of microorganisms and can impair the performance of the filter. This is why periodic cleaning is a necessity for proper operation of the humidifier. Rinse, wipe clean and dry with a clean cloth or paper towel. Be careful that you do not damage the delicate wick. Model 3400: Turn switch to the ON position, either Low speed (I) or High speed (II). Turn switch to the Off (O) position (Models 3300 and 3400 only) and unplug the cord from wall outlet. Models 3000, 3300 and 3400: Remove Wicking Filter from the Base by carefully pulling straight up. Be careful not to bend or break any of the Support Ribs (see Figure D). Model 3020: Remove Wicking Filter from the Base by carefully pulling straight up. Dampen soft, clean cloth or sponge with undiluted white vinegar and wipe out Base (and Indicator Float on Models 3300 and 3400) to remove scale. Rinse thoroughly in clean warm water to remove scale and vinegar before disinfecting the Base. Fill Base with 1 teaspoon of household bleach in 1 gallon of water. Let solution remain for 20 minutes, stirring every few minutes to insure that all surfaces are coated. Rinse with water until bleach smell is gone. Wipe all exterior surfaces of the Top Housing with a soft, dry cloth. [. . . ] excessive humidity is indicated by condensation on cold surfaces or walls in the room. For proper humidity readings, use a hygrometer available in most hardware and department stores. Models 3300 and 3400 are warranted against defective material or workmanship for 3 years from date of purchase. Models 3000 and 3020 are warranted for 1 year from purchase date. [. . . ]