User manual KAZ BP 2590

[. . . ] The importance of the blood pressure measurement in the practice's environment calls for a high performance standard with regard to quality and reliability of the professional measuring device. Moreover, the device monitors the appropriate positioning at definite intervals during the measurement cycle, thus providing additional safety and reliability. This watchdog feature allows patient self measurement in the practice, which may be beneficial in reducing the problem of white coat hypertension. With its technical design, Braun PrecisionSensor pro is the ideal supplementary device for the medical practice. [. . . ] Make sure the appliance is positioned approximately at the person's heart level. Move the forearm of the patient up or down (see illustration) in the direction of the arrow. When a measuring position has been reached, you will hear an acoustic signal and the display shows a heart symbol. When the measurement is complete, an acoustic signal will sound again, and the reading is displayed. Upper (systolic) value Lower (diastolic) value Pulse Additionally, on the upper display section, three status boxes will appear to confirm that the appropriate measuring position was kept during the complete measuring process. all three boxes have to show «OK». If the following symbols («r» = too high; «w» = too low) appear, the appropriate measuring position was not maintained and the measurement has to be repeated. Important 15 seconds after switching on the device, the measuring process will begin automatically, even if the appropriate measuring position has not been reached. If at any time you want to discontinue the measurement, press the I/0 button. The blood pressure monitor can store up to 30 readings along with the status box information. Readings are stored automatically after each measurement. To recall stored readings, first switch off the device. Repeatedly pressing the memory button will call up one by one all stored readings (including status box information). The number in the upper left corner of the display indicates the memory position (01 being the oldest, 30 the most recent). Holding down the memory button for more than a second will delete all memory data completely. After clearing the memory, the appliance will turn off automatically. Otherwise the product will turn off automatically after 2 minutes. Measurement on patients in supine position When taking a reading on a patient in supine position the appropriate measurement position at heart level of the Braun PrecisionSensor pro device is normally achieved automatically. The active positioning system is not needed in this case. In order to guarantee a correct measurement the position sensor should be switched off for the measurement (refer to «Pre-setting the position sensor»). Prevailing measurements on persons lying down, it may be necessary to de-activate the position sensor. For this purpose, you will find a select button (D) underneath the battery compartment cover. [. . . ] All other claims, including for damages, are not covered by this guarantee. Service under the guarantee does not affect its expiry date. Claims only valid in countries where product is officially sold and if accompanied by a stamped and dated guarantee card. Claims arising out of the sales contract with the vendor are not affected by this guarantee. [. . . ]