User manual KAZ BP 3510

[. . . ] The World Health Organisation (WHO) has set up the following standard blood pressure values when measured at resting pulse. What you should know about this blood pressure monitor For accurate measurements, all wrist blood pressure monitors must be positioned at heart level. Example: If the monitor is positioned 20 cm below heart level as shown on the left (e. By putting the arm on a table), the reading you will obtain is approximately 15 mmHg too high. [. . . ] Your blood pressure monitor can store the readings of 50 measurements. Storing is done automatically after each completed measurement. This means that you will not loose stored data when changing batteries. Once the memory is full, the oldest values will be overwritten. Recalling stored readings To recall stored readings, first turn the product off, then press the memory button (D). a single push (m or n) will recall the latest reading. The lower display line successively shows memory index and pulse on the one hand and date and time of the respective measurement on the other hand. Repeatedly pressing the memory button (D) will call up one by one all stored readings: m (­) towards older readings n (+) towards younger readings Scrolling Keep one side of the memory button pressed for scrolling through the memory. Push the select button (C) for longer than 3 seconds to enter the select mode. The day position of the displayed date starts flashing. Using the memory button (D), you can adjust the date. Press the select button again to make the month position flash, adjust it using the memory button. Press the select button again and proceed the same way to adjust the time (hour/minute). After having changed date and time, press the on/off button (B) to confirm. Because you want to measure while lying down), proceed as follows: Turn off the product. Push the select button (C) for longer than 3 seconds and wait for the confirmation beep. the display shows the date and time settings. Then repeatedly press the select button until the positioning system symbol ( ) will be displayed next to a flashing «ON». Press one side of the memory button to change the setting from «ON» (positioning system activated) to «OFF» (positioning system deactivated). to confirm the change of setting , press the on/off button (B). Please note: Unless you confirm a modified setting by pressing the on/off button, the appliance will turn off automatically after 2 minutes without adapting the modified setting. Clean the product with a soft, slightly damp cloth. [. . . ] The distance aid helps you to keep the required 2 cm distance to your palm line. To close the cuff, hold the appliance against your body. Then take hold of the cuff closure, pull out the cuff and insert the cuff closure in the monitor housing until it locks into place. Once cuff is closed, do not move the appliance anymore. [. . . ]