User manual KAZ HCM-315T

[. . . ] If it still does not fit, contact a qualified electrician. DO NOT attempt to defeat this safety feature. To disconnect the humidifier, first turn controls to the OFF position, then grip the plug and pull it from the wall outlet. Never pull by the cord. 8. A loose fit between the AC outlet (receptacle) and plug may cause overheating and a distortion of the plug. [. . . ] Kaz will not accept responsibility for property damage caused by water spillage. Soak Filter Step 1 Step 2 Step 3 Remove the water tank and carefully set aside. Remove the filter from the holding basket. DO NOT squeeze filter. Step 2 Place wet filter back in the filter holding basket and place back in unit. Fill Tank Step 1 Step 3 Turn tank upside-down. Remove tank cap by turning counterclockwise . Fill tank with cool tap water. Place tank back on humidifier. Once the filled water tank has been placed on the unit do not move humidifier. Doing so could cause leakage and spills. Power Step 1 With the power switch in the OFF position, plug the filled humidifier into a polarized 120V outlet. DO NOT FORCE THE POLARIZED PLUG INTO THE OUTLET; it will only fit one way. DO NOT plug in humidifier with wet hands to avoid electric shock. 4 HCM-300T_HCM-310T_OM. qxd 5/22/06 5:56 PM Page 5 OPERATING YOUR HUMIDIFIER Model # HCM-300T Output/Fan Speed Control Step 1 Set Humidity Step 1 Step 2 Set fan speed to desired output: High ( ) Fast Humidifying Medium ( ) Everyday moisture control Low ( ) Nighttime or maintenance use HCM-310T/ HCM-315T Step 1 Turn the humidistat knob clockwise to the highest setting ( ). Run on high for at least 1 hour or until room has reached a comfortable humidity level. Then slowly turn the humidistat knob counterclockwise until the humidifier shuts off. The desired humidity light will illuminate. Once set, the humidifier will automatically cycle on and off based on your setting. Step 1 Press power to start unit in high speed. Max: 55% Min: 35% Use the (+) up or (­) down button to set desired humidity. The unit will operate until the selected humidity is reached or the unit is turned off. When desired humidity is reached, the fan will shut off but LED will remain lit. The fan will turn back on when the room humidity drops below the set level. NOTE: To go back to continuous run mode, turn your unit off and on again. Step 2 Push (+) Up button or (­) Down button to select the output level. NOTE: The UV bulb can be turned off and on using the button. 5 HCM-300T_HCM-310T_OM. qxd 5/22/06 5:56 PM Page 6 NOTE: It is recommended that all maintenance be done in the kitchen or bathroom on a water resistant surface. Remove water tank from unit before moving. CHANGING YOUR FILTER The filter should be changed every 1-3 months depending on your water quality. Keep in mind, depending on your water quality, mineral deposits can still clog or discolor the filter, affecting it's life and that of the humidifier. It is recommended you change your filter in the bathroom or kitchen. Keep in mind your filter may be damp depending on your last usage. To change the filter: Step 1 Step 2 Step 3 Step 4 Uses replacement filter HAC-504 or HAC504AW. Step 5 Turn off and unplug your humidifier. Step 6 Remove the water tank and carefully set aside. Step 7 Remove filter holding basket and discard old filter. Soak new filter in cool water. CHANGING THE UV BULB Insert new filter into holding basket and place filter holding basket back in unit. Replace the water tank. The UV bulb will operate for an average output of 10, 000 hours. To replace UV bulb contact 1-800-477-0457 or consumerrelations@kaz. com. Step 1 Step 2 Step 3 Turn off and unplug your humidifier. 6 Remove the water tank and carefully set aside. Press on the button located on the side of the UV bulb. Carefully use your other hand to pull the UV cartridge away from the unit. HCM-300T_HCM-310T_OM. qxd 5/22/06 5:56 PM Page 7 CHANGING THE UV BULB (CONT'D. ) Step 4 Step 5 Step 6 Place your replacement UV bulb in the unit by pressing the UV bulb firmly into the opening. [. . . ] This warranty applies only to the original purchaser of this product from the original date of purchase. At its option, Kaz will repair or replace this product if it is found to be defective in material or workmanship. Defective product should be returned to the place of purchase in accordance with store policy. Thereafter, while within the warranty period defective product may be returned to Kaz. [. . . ]