User manual KAZ HHT-080

[. . . ] Do not use air cleaner where combustible gases or vapors are present. Do not expose the air purifier to rain, or use near water, in a bathroom, laundry area or other damp location. The air purifier must be used in its upright position. Do not allow foreign objects to enter ventilation or exhaust opening as this may cause electric shock or damage to the air purifier. [. . . ] The LED light will no longer be illuminated. ELECTRONIC FILTER CLEAN REMINDER This model air purifier has an electronic filter check to remind you when to check and clean the HEPAType filters based on the air cleaner's hours of use. When the HEPA-Type filters need to be cleaned, the light will remain on until it is RESET. You may unplug the air cleaner without interrupting the filter check. A red LED light will illuminate when it is time to clean the filter. you should periodically check the filter. Depending on operating conditions, the filters should be cleaned every 6 months to a year. Will illuminate when it is time to clean HEPA filters When the filter monitor light remains on, it is time to check/clean the HEPA-Type filters and reset the filter monitor, if needed. With the unit powered on, insert the tip of a ball-point pen or paperclip next to the LED filter check light and hold for approximately 5 seconds until the light turns off (Fig 5a & 5b). Depending upon your individual usage (environment and hours used), you may need to check and clean the filters more or less frequently. If the HEPA-Type filters are cleaned before the filter monitor light turns on, the filter monitor should be reset at the same time. These cleaning intervals are intended as guidelines only. Performance of any filter media is dependent upon the concentration of contaminates going through the system. OSCILLATION FEATURE (MODEL HHT-100 SERIES) To help circulate fresher, cleaner air through the room, this unit has an oscillation feature. To turn Oscillation on, simply press the Oscillation button ( · CLEANING THE HEPA-TYPE 1 WASHABLE PARTICLE PRE-FILTER MAINTAINING YOUR STAGE FILTERS The Honeywell models HHT-080 Series and HHT-100 Series are equipped with permanent HEPA-Type filters which never need replacement with normal use. To vacuum-clean the filter, hold the filter and run a vacuum cleaner with a nozzle or brush attachment along the filter to pick-up the dirt and particles (Fig. Repeat along the entire surface of the HEPA-Type filter. Note the filter may still be discolored even after cleaning it. This is acceptable and will not affect performance. After vacuuming the filter, place it back into the air purifier housing and snap filter grille into place. [. . . ] Defective product should be returned to the place of purchase in accordance with store policy. Thereafter, while within the warranty period defective product may be returned to Kaz. This warranty does not cover damage resulting from any unauthorized attempts to repair or from any use not in accordance with the instruction manual. This warranty DOES NOT cover the washable pre-filter or the HEPA filters, except for material or workmanship defects. [. . . ]