User manual KAZ HZ-2200

[. . . ] HZ-2200-3200-3220_OM_Rev1. qx 6/8/05 1:19 PM Page 1 TOWER SURROUND HEATERS Model HZ-2200 Series Model HZ-3200 Series Model HZ-3220 Series wider than the other). To reduce the risk of shock, this plug is intended to fit only one way in a polarized outlet. If the plug does not fit securely in the outlet, reverse the plug. If it still does not fit, contact a qualified electrician. [. . . ] · Turn the heater on using the Child Resistant Switch (Power knob). To operate the switch, push in the two sides of the Power knob while turning it clockwise to the desired position (Fig. The Child Resistant Switch helps to keep the heater from being turned on unintentionally; there is no way to disengage this safety feature. · When the room reaches a comfortable temperature, slowly turn the Thermostat control counterclockwise until the heating element goes off (the power light will remain on). This is the point at which the Thermostat setting equals the room temperature. At this setting, the Thermostat will automatically turn the heater on and off to maintain the selected temperature. · Push down and turn the Power knob to OFF and unplug the heater when you are finished using it. Fig. 1 Forward Only Heating (One Direction Heating) HZ-2200-3200-3220_OM_Rev1. qx 6/8/05 1:19 PM Page 4 HZ-3200 OPERATION · The Tower Surround Heater is designed to disperse heat in either a Fig. 4 360° range or in one direction only. To select the desired heating mode, slide the Direction Control switch, located on the top of the heater, to the position of your choice (Fig. 4): ­ to the left ( ) for 360° Heating 360° Heating ­ to the right ( ) for Forward Only Heating (One Direction Heating) · With the Power knob in the OFF (O) position, plug the heater into a polarized 120V outlet. DO NOT FORCE THE POLARIZED PLUG INTO THE OUTLET; it will only fit one way. · Turn the Thermostat control fully clockwise to the HIGH setting. · This heater is equipped with three different heat settings. The Low setting ( ) uses 600 watts of power, the Medium setting ( ) uses 900 watts of power and the High setting ( ) uses 1500 watts of power. You can select the proper setting to accommodate your comfort level. Because the Low and Medium heat settings do not require as much electricity to operate, they are more energy efficient and may be better options if you are concerned about the amperage draw on a circuit when the heater is in the High setting. Fig. 5 Power Knob Power Light Thermostat Knob Forward Only Heating (One Direction Heating) · Turn the heater on using the Child Resistant Switch (Power knob). To operate the switch, push in the two sides of the Power knob while turning it clockwise to the desired position (Fig. The Child Resistant Switch helps to keep the heater from being turned on unintentionally; there is no way to disengage this safety feature. [. . . ] NOTE: This feature will not keep the heater from being turned on. It will, however, keep the controls from being adjusted once the heater has been set. Fig. 10 HZ-2200-3200-3220_OM_Rev1. qx 6/8/05 1:19 PM Page 6 SAFETY FEATURES These heaters are equipped with several devices and features for added protection: · SafeGuardTM Alert Heat Indicator Badge visually indicates the grille is hot by turning from black to red (HZ-3220 Series only). When the grille begins to cool after the heater is shut off the badge will turn black again. [. . . ]