User manual KAZ HZ-7020

[. . . ] Do not cover cord with throw rugs, runners, or the like. Arrange cord away from traffic areas where it will not be tripped over. This appliance has a polarized plug (one blade is wider than the other). To reduce the risk of shock, this plug is intended to fit only one way in a polarized outlet. [. . . ] · The heater will turn back on when the room temperature drops approximately 2 degrees below the desired temperature. The Power light will stop blinking and will remain lit. OSCILLATION (HZ-7020, HZ-7030, HZ-7040 SERIES) Power Mode Oscillation F/C · The Oscillation feature functions in any power or mode setting. · Press the Oscillation button to toggle this feature on and off. 2 BACK-LIT DISPLAY (HZ-7000, HZ-7010 SERIES) POWER: Power Mode Back-Lit F/C Power · The Back-lit feature provides light to the heater display and functions in any power or mode setting. · Press the Back-lit button to toggle this feature on and off. Basic Remote LCD Remote FOOT PEDAL (HZ-7010 SERIES) · Press Power once to start the heater on High Power, Continuous Run. · Press Power again to change to Low Power, Continuous Run. · Press Power a third time to turn the heater off. MODE: SET TEMPERATURE Temperature Mode Adjust Up or Down · The Foot Pedal works the same as the Power button. · Press the Foot Pedal once to start the heater on High Power, Continuous Run. · Press the Foot Pedal again to change to Low Power, Continuous Run. · Press the Foot Pedal a third time to turn the heater off. Basic Remote LCD Remote REMOTE CONTROL OPERATION Two (2) AAA batteries required. Models HZ-7030 and HZ-7040: Remote Control included when originally purchased. Models HZ-7000, HZ-7010 and HZ-7020: Remote Control may be purchased separately at www. honeywellconsumerproducts. com. The Remote Control works the same as the corresponding buttons on the Control Panel. The Control Panel display on the heater will show the appropriate icons when the various functions are activated. 3 · Press Mode until the Temperature icon blinks on the Control Panel. The current room temperature will also appear on the Control Panel. · Use the Up or Down arrows to set the desired temperature. · The Temperature icon will stop blinking and the current room temperature will reappear after the desired temperature is set. · The heater will turn-off shortly after the desired temperature is reached and the Power light above the display will blink. · The heater will turn back on when the room temperature drops approximately 2 degrees below the desired temperature. The Power light will stop blinking and will remain lit. MODE: SET TIMER Timer BACK-LIT DISPLAY (HZ-7000, HZ-7010 SERIES) Mode MODE MODE Adjust Up or Down Back-lit LCD Remote Basic Remote · Press Mode until the Timer icon blinks on the Control Panel. The Hour display will also appear on the Control Panel. · Use the Up or Down arrows to set an operation time between 1 and 10 hours. [. . . ] At its option, Honeywell will repair or replace this product if it is found to be defective in material or workmanship. Defective product should be returned to the place of purchase in accordance with store policy. Thereafter, while within the warranty period defective product may be returned to Honeywell. This warranty does not cover damage resulting from any unauthorized attempts to repair or from any use not in accordance with the instruction manual. [. . . ]